Selby LCD482-T User manual

English
Installation Instruction
1
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
! Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
! Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

Supplied Par ts List
2
CAUTION!
WARNING
!This monitor desktop mount must be securely
attached to the horizontal desk. If the mount is
not properly installed it may fall, resulting in
possible injury and/or damage.
Tools Required Phillips Screwdriver
(12)M4 Space-g(12)M4x12 Bolt-d (12)M4x30 Bolt-e (24)M4 Washer-f
(2)M8x10 Bolt-h (2)M10x15 Bolt-i (1)Allen Key-j (2)Spare Plastic
Cover-k
(1) 48mm Tube
Support-a
(1) VESA Plate with
Arm Assembled-c
(1) Disconnected
“C” Clamp-b (1)Wrench-l

Step 1 Install the “C” Clamp According to the Desktop Thickness
3
Step 2 Install Arm to the Tube Support
a
b
i
j
c
h
The depth of “C” clamp can be changed in
three positions. Choose the proper depth
acc o r di n g to t he thi c k ne s s of y ou r
desktop. Connect it by 2pcs M10x15
bolts(i), using the supplied Allen Key(j).
Install arm to the tube support,
please make sure the wire clip
in the downside. Fasten the
bolt by screw driver.

4
Step 3 Mount the Monitor to VESA Plate
Step 4
Step 5
Manager the Wires and Adjust the Turning Tension
For Flat Back Monitor For Curved Back Monitor
Fix the Tilt Angle and Adjust the Level of the Monitors
d
f
e
f
g
l
Remove the plastic cover,
t i g h t e n t h e n u t b y t h e
Wrench(l) to fix the tilt angle.
Fix the tilt angle
j
Remove the plastic cover, use
the Allen Key(j) to adjust the
turning tension.
Manager the wires by the wire
clips, some wires can be
hidden inside the pipe.
Loosen the bottom bolt and
fasten the top bolt to lower the
center monitor.
Level Adjustment