Electric Kettle
SWK 1031SS
EN
EN-7
2020 08/2020
DESCRIPTION OF THE CONTROL PANEL
Operation of kettle
Priortouse,removeallpackagingmaterial from the kettle.Set the required length oftheelectric cable. Press the electric
cable into the groove in the stand.
Place the stand on a stable, flat and dry surface.
Fill the kettle with the required amount of water. You can fill the kettle by the spout, or by opening the lid. The water
must cover the guideline minimum and must not exceed the guideline maximum.
Warning! In case the kettle is overfilled, this can lead to the spurting of boiling water.
Place the kettle on the detachable stand.
Insert the plug into the electric socket.
Toturn the kettle on press switch with the symbol down. Note: Prior to turning it on,make sure the lid is well shut.
As soon as the water is boiled, the kettle will be turned off automatically.
Prior to removing the kettle from the stand, make sure it has been automatically turned off first. In case it is not
automatically turned off, turn it off manually.
After use, remove the electric cable from power point and let the kettle cool.
Never fill the kettle while placed on the removable stand.
Do not turn on the kettle and use it without water.Incorrect use may adversely affect the operation life of the appliance.
In case you accidentally turn on the kettle without water, the thermoregulator automatically cuts off the electric circuit
once it has reached a certain temperature and the light controlturns off. After several minutes, once the stainless-steel
bottom has cooled, it is possible to use to kettle again.
CLEANING THE KETTLE AND FILTER
The removable filter serves to hold back limestone and prevents it from getting into the cup when water is being
poured. It is necessary to clean the filter under running water on a regular basis.
Remove limestone scales on a regular basis, at least 1× month.
To remove limestone scales, you can use:
- 8 % white vinegar, readily available in shops. Fill the kettle with ½ l of vinegar and let it stand for 2hours.Then empty
the kettle and boil clean water 4-5 times prior to use.
- citric acid. Boil ½ l of water in the kettle, add 30g of citric acid and let it stand for 30minutes. Then empty the kettle
and boil clean water 4-5 times prior to use.
To clean the exterior part of the kettle use a dry cloth or a cloth dampened in a weak solution of neutral dish liquid.
To clean the stand, only use a dry cloth.
To clean the kettle, its components or accessories, never use cleaning agents that cause scratches, gas, thinners, etc.
