EN-9
2016 02/2016
USING THE WATER KETTLE
1. Using the water kettle to prepare tea
1.1 From the bottom of the stand A6, unwind the necessary length of power cable. Pull the power
cable through one of the three slots in the base. Put the stand A6 on an even, dry, stable surface.
1.2 If the water kettle is on the stand A6, remove it. Grasp the handle A1 and remove the lid from the kettle.
Note:
If the internal lid A2 is set to locked position, pull the handle A1 to remove the external lid
A2 and A3 at the same time.
Fill the kettle with the desired amount of water. The water level must at least reach the minimum
mark (0.5 l) and must not exceed the maximum mark (1.2 l).
Warning:
Fill the kettle only with potable water.
Never fill the kettle when it is placed on the stand A6.
If the water kettle is overfilled, boiling water may splash out.
1.3 Firmly close the kettle with the lid. The outer lid A3 must attach all the way around the neck of
the kettle. The internal lid A2 must be set to locked position, i.e. the arrow on the internal lid A2
must be even with the closed lock icon on the external lid A3.
1.4 Put the kettle on the stand A6 and plug the power cable in. After the stand A6 is plugged in, an
acoustic signal (three beeps) will sound, and the lights on all control buttons will briefly glow white.
Then the control panel switches to “Ready”, which means you can use the kettle.
Note:
If the stand A6 is plugged in first, the white START/STOP Aqs and Green Tea A8 control lights
go on.
When the stand A6 is plugged in again, the white START/STOP Aqs button lights up, as does the
temperature setting button that was last used before unplugging the stand A6.
1.5 Press the appropriate button, A8, A9, A0 or Aqa, to choose the optimal temperature for preparing
the elected type of tea. The relevant button lights up white when it is pressed. The START/STOP Aqs
button also glows white. To start the water heating to the set temperature, press the START/STOP
Aqs button. The control light of the START/STOP button Aqs glows red.
1.6 As soon as the water gets to the desired temperature, 5 beeps sound to indicate the temperature
has been reached.
Note:
If you remove the water kettle from the stand A6 while it is heating water, heating automatically
stops and the panel automatically switches to “Ready”.
1.7 “Keep Temperature” mode
After the water has been heated, the kettle automatically switches to “Keep Temperature” mode. In
this mode, the kettle maintains the set water temperature for no more than 10 minutes. The button
for setting water temperature blinks white, and the START/STOP Aqs button still glows red. During
this time, it is necessary to prepare the tea for brewing and switch the kettle to brewing mode.
Grasp the handle A1 on the internal lid A2 and turn the lid A2 counter-clockwise, so that the
arrow shown on the internal lid A2 is even with the open lock symbol on the outside of lid A3.
Carefully remove the lid A2. Be sure not to get scalded by the steam that can escape from the slot
in the lid A3. Prepare the tea strainer Aqf and put the proper amount of tea into it. Grasp the tea
strainer Aqf by the handle Aqd, and insert it into the slot in the external lid A3. The edge of the
strainer Aqf must click into the slot all around the external lid A3. The handle of the strainer Aqs
must be placed above the handle Aqg, which is used for carrying the kettle. Close the slot in the
external lid A3 using the internal lid A2.
