SEPTENTRIO PolaRx5S User manual

PolaRx
5S
To set up the PolaRx5S you will need:
Antenna
5
. Basic Monitoring
•
•
•
WiFi capable device
Antenna cable
USB cable
Power adapter
For more information:
The memory stick delivered with the PolaRx5S
contains the following documents:
You can also consult our webpage or contact our
Support Department:
Is the PolaRx5S tracking satellites?
•
Click 'Show table' on the
Spectrum plot then select
GPS L2-P(Y). This frequency
band can be vulnerable to
interference.
•
Select the 'GNSS' tab then 'Spectrum'
•
Select the 'GNSS' tab then
'Satellites and Signals'
•
In open sky, the PolaRx5S
should track between 15
and 25 GPS and Glonass
satellites.
•
The Carrier-to-Noise plot
for GPS should show
about 3 satellites with an
L1CA above 50 dB-Hz
•
Quick Start Guide
PolaRx5S User Manual
PolaRx5S Firmware Manual
SBF Reference Guide
http://www.septentrio.com
The small GPS L2 signal at
1227.6 MHz should be visible.
Other spikes or anomalous
activity in the spectrum may
indicate interference.
Is there any interference?
•
or
[email protected]

•
•
•
1. Powering up
2. Connecting an antenna
3. Turning on the WiFi
•
Connect one end of the antenna cable to the antenna
and the other end to the rear
-
panel ‘
Main
’ socket on
the PolaRx5S
•
Make sure the antenna has a clear
view of the sky
•
Press firmly on the front
-
panel Wi
Fi button to turn on
the WiFi modem
Connect the power adapter to
the ‘
PWR
’ socket
on the
PolaRx5S front panel
Plug the
power adapter into the mains
The PolaRx5S will start up automatically
•
4a.
4b.
Connecting to the PolaRx5S over
USB
•
Connect the USB cable between
the PolaRx5S and your PC
or
When connected, open a
web browser using the IP
address:
•
192.168.20.1
•
Wait for the drivers to fully
install
•
Find the PolaRx5S WiFi
signal on your device
and click:
Connect
•
When the drivers have
installed, open a web
browser with the IP
address:
192.168.3.1
Connecting to the PolaRx5S over
WiFi