Serene House Donut II User manual

www.serene-house.com
Instruction Manual
Donut II / Design by Carsten Jörgensen
Paris•London•New York•Taipei•Shanghai

2 3
Please read this manual carefully before using the Scentilizer.
After reading this manual,
please keep it in a readily accessible place.
Table of Contents
Main Unit....................................................................................04
Accessories...............................................................................05
Operating Instructions..........................................................06
Remote Control......................................................................09
Cleaning & Maintenance.......................................................12
Safety Precautions...................................................................14
Specifications............................................................................17
Troubleshooting......................................................................18

4 5
1 32
Power Audio USB 65
Water mark
(230ml)
The Product Accessories
Donut II（111101005 White / 111101006 Black）Please check if all the following items are present and if there is any damage before use.
Main unit Glass cover Sensor
Audio cable
4Waterproof
cap
Vent coverCleaning brush
Remote
control
AC adapter
Vent
Ventilation
inlet
Spray hole
Atomizer Speaker

6 7
• Always place your Scentilizer on a firm, flat, and level surface.
• Please filter the tap water to reduce the limes before use.
• For best result, do not use pure water, distilled water or
other liquids.
• Water should be in room temperature（25℃ ~ 40℃）
（76.9˚F-103.9˚F）Do not use water below 25℃（76.9˚F）.
• Never add water into the vent hole.
1
3
4
5
2
• Be sure to follow this instruction to prevent water from
flowing into the vent hole and causing malfunction.
Opearating Instructions
• Condensation may form on the Scentilizer causing the floor to become wet during summer
when humidity is high or during winter when room temperature is low.
Remove the water level label and place the vent
cover into the vent in the tank.（as shown in diagram
left）.
Add water slowly into the water tank and make sure
the water level does not exceed its designated water
mark level. Please avoid adding water near
the vent area.
Add 5-10 drops of SERENE HOUSE 100% natural
essential oil into the tank.
Please do not let the essential oil drip onto the
exterior of the Scentilizer.
Make sure the vent cover is correctly icovering the
vent（as shown in left diagram）and the glass cover
is properly in place. Use a clean cloth to gently wipe
the surface of this Scentilizer, if needed.
Insert the AC adaptor into the socket of the main unit,
as shown in the left diagram.
2
1

8 9
CR2032：
Lithium battery,
included.
6
7
8
9
Remote Control
POWER BUTTON :
Turns the machine on and off.
LIGHT BUTTON :
Turns the LED light on and off.
ATOMIZING BUTTON :
Controls the atomization mode
normal / strong / off.
TIMER BUTTON :
Sets the machine’s automatic off time,
30 / 60 / 90 minutes and continuous mode.
MUSIC SELECTION BUTTON（Up）:
Selects the previous track when using the USB
playback function.
MUSIC SELECTION BUTTON（Down）:
Selects the next track when using the USB
playback function.
USB BUTTON :
Plays the music files in the USB device.
DEFAULT BUTTON :
Plays the built-in music.
AUDIO BUTTON :
Plays the external 3.5mm audio input port’s
music.
VOLUME ADJUSTMENT BUTTON :
Increases the volume of music.
VOLUME ADJUSTMENT BUTTON :
Reduces the volume of music.
Front
Use the remote control and press the power button
to start the unit.
The machine starts to operate.
The built-in LED lights of this Scentilizer will flash when the water level is near
empty. The Scentilizer will automatically stop operating shortly after. For immediate
re-use, please empty the residual water and replenish water accordingly.
For the best performance, make sure to clean your Scentilizer after each use.
• Please follow the instructions on page 12 in this manual for proper cleaning and maintenance.
• The remote control goes off to power-saving mode when
not in used for more than 10 seconds.You may press any
button to restore the default status or continue to perform
other operations.
2
1
back