Serious readers alex rechargeable User manual

Serious Readers | Chapel Offices | Bierton | Bucks | HP22 5DW | Great Britain
Contact us
If you require any assistance or spare bulbs, please call [phone]
(Mon-Fri 8:30 to 17:30)
Bulb Change
Diagram 4
Screw action
shade for easy
bulb access
To undo
Changing your Bulb
Disconnect your light from the power. If
the light has been on recently, allow 30
minutes for everything to cool down. To
access the bulb cavity unscrew the ribbed
front section by rotating anti-clockwise
(diagram 4).
Pull out the old two pinned bulb without
twisting. Insert the new bulb by pushing
the two male pins into the two female
holder sockets.
Replace the front shade by screwing it
back on to the lamp head.
1
2
3
SR089
Alex Rechargeable
[phone] [phone] [email protected] www.seriousreaders.com
Serious Readers
Brighter by Design®
alex rechargeable
for serious readers
Your User Guide
Please Read
 keep for reference
alex rechargeable

Pen & Glasses holder
Diagram 3
(only available on Heavyweight
Table Model)
1. Squeeze + Li
2. Li 2. Li
1. Squeeze + Li
Alex Rechargeable the original
Alex Rechargeable
Charging
Diagram 1
Stay-put
Flexible Arm
Stay-put
Flexible Arm
On/O Switch
On/O Switch
Heavy stay-put
Base
On/O Switch
Getting Started
Your Alex Light is ready to plug in and use.
To operate the light, use the on/o switch
located on the head of the light (Diagram 1).
Your on/o switch will have a 0/1 marking
on it. e rechargeable light is only available
in a non-dimmable format.
Positioning
Your light is designed to help you easily
direct the beam just where you need it. It
is equipped with a swivel joint at the lamp
head and a robust, exible, stay-put arm for
ne positioning.
Recharging
e light is delivered fully charged and
provides a minimum of 4 hours continuous
use. ere will be no loss of light output as
the battery charge drops.
e light can be recharged using the
supplied power unit. e charging point
is located on the base of the light (see A of
diagram 2). Whilst charging a red light is
visible on the charger. Once fully charged
this light reverts to green (see B of diagram
2). e recharging time varies from 90 to
120 minutes.
e light can only be used indoors.
Standby Mode
e Alex Light is not designed to be opened
so please do not attempt to tamper with it.
It is normal to leave the light on standby
when not in use. When in standby mode it
will consume less than 0.5w.
Table Accessories
e table model is equipped with pen and
glasses holders. ese can be removed if you
wish. e retaining cap releases if squeezed
and lied.
If it seems a little sti you can loosen it
by gently levering the two plastic arms on
either side together. Once the retaining
cap has been released, remove one or both
holders then push the cap back into place
(Diagram 3).
Diagram 2
A B