Seuic AUTOID Pad Series User manual

it is been fully charged.
Open the rubber cap, there are two card slots, the one on top is
for SIM card and the other one is for SD card. Insert the SIM into
the corresponding slot in according to the direction sign until the
notification of sound or vibration. Then insert the SD card in the
same way.
Note: The AUTOID Pad does not support hot-plug, please restart
the device after accident hot-plug.
QUICK START GUIDE
Company address: NO.15 Xinghuo Road, Nanjing New High
Technology Industry Zone, Nanjing City, Jiangsu Province,
China
Hotline: [phone]
Company official website: www.seuic.com
Products official website: www.chinaautoid.net
Mailbox: AUT[email protected]
Post code: 210061
Light sensor
Rear camera
On initial use of the device or opening of some applications,
quick tips will pop up to guide you on how to use them.
Operating menu will pop up after long press on power button,
then choose Power off to shut device off.
Charging dock interface
charging dock.

Please check whether the scan engine is open or closed.
Please check whether the Seuic’s integrated scan tool and
the third party application are opened simultaneously. If yes, close
the Seuic’s integrated scan tool and disable the “Automatically on
when power on”.
If the AUTOID Pad is unable to connect to a PC, please check
whether the USB cable and the Autoid Pad is correctly connected.
If the device sleep mode cannot be activated, please check
wheter network data exchange is working or whether the FLASH
and NAND are in the operating process of reading and writing
data.
End flap cable: Use the end flap cable to connect the AUTOID Pad
with PC or charging adapter, red indicator means under charging
while green indicator means it has been fully charged.
ROM
Note: End flap cable, charging dock and USB cable cannot be
used simultaneously. In case of the device be idle for quite a
long time, please charge it at least once every two months to
avoid overdischarging.
Seuic’s integrated scan tool and the customers’ scan tool are
optional to use in scanning barcodes.
One scan results in two barcodes.
Charging dock: First place the end flap AUTOID pad into the
charging dock, then plug one end of the charging cable into the
power port of the charging dock and the other end to power
supply. Red indicator means it’s being charging and green
indicator means it has been fully charged.
Single slot charging dock
Note: If both WLAN and mobile data are opened simultaneously,
WLAN will be of higher preference. When WLAN is inaccessible,
the device will pop up notification to check whether to use the
mobile data.
Please restart the device after replacing the SIM card.