Sevylor INFLATABLE STANDUPPADDLEBOARD User manual

s
SHEET 1 OF 1
Wichita, Kansas USA 67219
The Coleman Company, Inc.
COMPOSITE- NO
CRITICAL DIMENSION
cm3
REV.
MATERIAL:
SEE NOTES
SEE NOTES
1:1 18-JUN-13
Black
Program: InDesign CS4
Rainy X
INSTRUCTION MANUAL, SUP ENGLISH
CB
01
4010026068
SCALE:
NAME:
DATE: DRAWN BY: APPROVED BY: REVISION
FINISH
SPEC.:
DATE NAME ECN NO. MODIFICATIONS
grams
g/cm3
This drawing contains proprietary information and trade secrets of The Coleman Company, Inc.
Unauthorized use or copying is prohibited.
METRIC
[INCH]
CHECKING IS COMPULSORY
VOLUME 01 18-JUN-13 Rainy X 20029769
NEW
MASS
DENSITY
GENERAL TOLERANCES
EXCEPT AS NOTED
0 TO 6mm = ±0.1
>6 TO 30mm = ±0.2
>30 TO 80mm = ±0.3
>80 TO 180mm = ±0.4
>180mm = ±0.5
ANGULAR = ± 3°
PAR T
NO.:
DO NOT PRINT THIS PAGE
Printing Notes:
Material: 20 Pound (US) or 80 GSM (International) bound paper, white
Ink: Black
Resolution: 150 DPI or above
Printing method: Offset Printing
Binding: Saddle Stitch
Folded size: 5.5 x 8.5 in (W x H)

INFLATABLE STANDUP
PADDLEBOARD
READ THE FOLLOWING
INSTRUCTIONS AND WARNINGS TO AVOID
DROWNING OR SERIOUS INJURY
WARNING:
• Read owners manual before using this product.
• Not a life saving device.
• Not for use by children.
• Always wear an approved Personal Flotation Device (Life
Preserver).
• Inflate only with the included pump and do not over inflate.
• Do not overload & never go out alone.
• Never tow from another boat or vehicle.
• Use only in water away from debris and obstructions.
• Do not use in rapids or high surf.
• Do not use in high wind, strong currents, open water or dangerous tides.
• Never dive into the water from this board.
• Use of this product requires skill and physical ability. Should be
used by proficient swimmers only.
• Do not overestimate your ability or underestimate the forces of nature.
• Stay in contact with the board; always wear a leash (not included)
connected to you and the board. If separated, wind and current
can carry the board faster than you can swim.
• Never leave in or near water when not in use.
• Know and follow local water safety rules and boating regulations.
• Always check with the proper authorities regarding water and
weather conditions.
• Do not use this product under the influence of alcohol or drugs.
INFLATABLE STANDUP PADDLEBOARD
®
®
®
®

INFLATABLE STANDUP PADDLEBOARD
2
®
®
IMPORTANT INFORMATION
The warnings below relate to various situations. Please observe them.
CAUTION!
Denotes an imminent hazard which will result in severe injury if you
do not comply with the instructions.
WARNING!
Reminds you of safety measures which must be observed. Also
denotes unsafe practices which could result in personal injury or
damage to the product or property, if you do not comply with the
instructions.
CAUTION!
It is the owner's responsibility to make sure all users carefully
read and follow the instructions for safe operation of this
product. Observe all local and national laws. Always wear a
Personal Flotation Device approved by the proper authorities.
WARNING!
This product is not meant for towing and is not meant to be used in
whitewater.
CAUTION!
Altering the construction of this board could jeopardize the safety
of the user and will void the limited warranty.

INFLATABLE STANDUP PADDLEBOARD
3
®
®
CAPACITY & WARNINGS
WARNING!
Do not exceed the certied maximum capacities under any
circumstances!
WARNING!
Never use a compressor, CO2or compressed air to inate the board.
Do not let your board come into contact with sharp, pointed objects.
CAUTION!
Temperature will affect the pressure in inatable products. In
hot weather and direct sunlight, the air inside the board will
expand; check the pressure and deate the board slightly to avoid
overstretching the product due to overpressure.
CAUTION!
Do not over inate. Pressurize product to "Ination Pressure"
stated in the chart.
Persons Capacity Maximum Payload Capacity
Model # Persons Only Persons & Gear Inflation Pressure
Inflatable Standup Paddleboard 1 Pers. or 250 lbs. 250 lbs. 10.0 to 12.0 PSI
When inating for the rst time, inate indoors at room temperature.
The PVC will be soft and assembly will be easier. If the item was
stored below 0°C / 32°F, leave it at 20°C / 68°F for 12 hours before
unfolding. Inate it with the high pressure pump included with the
board. This pump has an adapter to t the ush valve.
ASSEMBLY & INFLATION / DEFLATION INSTRUCTIONS
CAUTION!
Do not use sharp tools!

INFLATABLE STANDUP PADDLEBOARD
4
®
®
FIN ASSEMBLY FOR BOARDS WITH 3 REMOVABLE FINS:
Before inating, affix the ns to the ttings on the bottom of the
board. To do so, squeeze the ttings together and snap the ns
into place.
Removable Fins
FIN ASSEMBLY FOR BOARDS WITH 1 REMOVABLE FIN:
This n may be added before or after ination. To attach, slide
n into slot on the bottom of board. Once in place lock into place
using the locking pin.
Locking Pin
Removable
Fin

INFLATABLE STANDUP PADDLEBOARD
5
®
®
All Ination is done in the LOCKED position and deation is done in
the OPEN position. When nished inating, replace the cap to prevent
sand, water and other debris from collecting in the valve cavity.
The recommended ination pressure is: 10 -12 PSI.
Use only the provided special high pressure pump to properly inate
the Inatable. Insert the nozzle at the end of the pump hose and
twist it clockwise. Be sure the pump is set in “Inating” mode and
start pumping. Periodically check the board pressure. The pressure
can be checked with the provided pressure gauge which measures
up to 30 PSI. See the enclosed pressure gauge instructions for a full
explanation of how to use.
INFLATION
The inatable is equipped with a rugged high pressure valve. Please
familiarize yourself with it before you start inating. The valve has
a screw-in cap attached with a Nylon cord. Unscrew the cap and
expose a notched center post. This is where you lock and open the
valve. Pushing down rmly with your thumb, rotate the post counter
clockwise to lock and clockwise to open the valve.
WARNING!
If you leave your product exposed to the hot sun check the pressure;
if the pressure is greater than 12 PSI, deate it slightly to avoid
overstretching the material.

INFLATABLE STANDUP PADDLEBOARD
6
®
®
CARE & STORAGE
•Deate the board. Remove the 3 ns. Leave the valve open
while you roll it up towards the valve.
•Close the valve to prevent moisture and debris from being
sucked inside as the air re-enters while you let go of the board.
•Cinch the tightly rolled up board with the belt-strap included.
•Never leave a wet board in the bag for more than one or two
days. As soon as possible unroll it and let it dry.
•Use fresh water for cleaning the board. Stubborn stains can
be cleaned with a mild soap detergent.
•Should it ever become necessary to repair your board,
please use the patches provided. Please use any good PVC
cement available in hardware stores. Many states have laws
preventing us from mailing glue.
REPAIRING
You can repair small punctures with the PVC patches supplied (Note:
Glue not included). Use a PVC type of glue found at hardware or
sporting goods stores for repairs). Please note that in order for the
repair to be successful, the humidity level should be less than 60%,
and the temperature between 18°C/64.4°F and 25°C/77°F. Avoid car-
rying out repairs in the rain or in direct sunlight.
Check that the board is fully deated and lies at.
1. Cut a round patch at least 2"/ 5 cm larger than the damaged area.
2. Clean the damaged area and the corresponding side of the
patch with an alcohol-based grease remover and allow it to dry
for 5 minutes.
3. Apply 3 thin layers of glue to both the patch and the damaged
area; allow it to dry for 5 minutes between layers until the glue
feels tacky.
4. When the third layer of glue is dry, apply the patch without
pressing down, and adjust the position if required. Remove any
air bubbles which may have formed under the patch by smoothing
the patch with a round object such as a spoon. Start in the center
of the patch and work towards the outside. Clean off the excess
glue. Drying: 12 hours.
WARNING!
•Perform repairs in a well-
ventilated area.
•Avoid inhaling glue vapors or
swallowing the glue.
•Avoid contact with the skin or
the eyes.
•Keep all repair materials
(glue, solvents, etc.) out of
the reach of children.

INFLATABLE STANDUP PADDLEBOARD
7
®
®
NOTES:

INFLATABLE STANDUP PADDLEBOARD
8
®
®
3600 North Hydraulic • Wichita, KS 67219 U.S.A.
1-800-835-3278 • www.Sevylor.com
© 2013 The Coleman Company, Inc. All rights reserved.
Sevylor® and
®
are registered trademarksof The Coleman Company, Inc.
4010026068 (ECN20029769-01)
®
®