Sewell BlastIR Wireless User manual

The BlastIR Wireless is designed to get your remote
control's signal where it needs to go. Control your
home theater video sources like Blu-Ray, DVD,
video players and receivers, and anything else that
uses a standard IR remote control through walls and
other obstructions by extending the IR signal wirelessly
with this kit. With our unique Multizone technology, you
have even more control over where you want your IR
signals to go and where not to go.
BlastIR Wireless

BlastIR Wireless IR Receiver
BlastIR Wireless IR Emitter
Dual IR Emitter Cable
IR Receiver Cable
(2) Airstick™ Microsuction Tape
(2) 3M Adhesive
(2) 5V .5A Power Supply
(2) USB to DC Cable
Box Contents
1

Setup: Step One
2
Connect each unit to power using either the
included power supplies or the USB to DC cables.
It is easy to mistake the IR cable port on the front
for the power port. Please ensure that the power
adapter is plugged into the appropriate port at
the back.
Insert power
cable here on
both units

Place the blue unit next to your display.
Setup: Step Two
3

Place the orange unit in front of the device that you wish to
control. Ensure that the IR emitter has a clear line of sight to
the IR “eye” of your device.
Setup: Step Three
4

If you want to extend the reach or hide the receiver or emitter,
connect the appropriate color-coded cable to the device. The
blue IR receiver cable will add another receiver you can point your
remote at. The orange IR emitter cable can attach to the IR “eye”
of the device you wish to control.
Optional IR Cables
IR Receiver
Cable
IR Emitter
Cable
5

Adhesive Placement
To keep the BlastIR Wireless in one place, we have included Airstick™
and 3M™ adhesive. Airstick™ is used as pictured above and it is designed
to be reusable and leave no residue. The 3M™ adhesive is used the same
way and is used for a more permanent placement.
6
Surface
AirStick™
White Side
Hole for the channel
selector on the bottom.
*Please carefully line
up when placing.
AirStick™
Clear Side

Channel 5
Channel 5Channel 7
Channel 7
0
9
6
8
7
4
1
3
2
5
0
9
6
8
7
4
1
3
2
5
0
9
6
8
7
4
1
3
2
5
0
9
6
8
7
4
1
3
2
5
Multizone
BlastIR Wireless Receivers will only communicate with the BlastIR
Wireless Emitters that are set to the same zone. The Blast IR
Wireless supports up to ten unique zones of communication.
Setting the zone to “0” will allow communication to previous
models of the BlastIR Wireless. After changing the zone, please
reset the device.
0
9
6
8
7
4
1
3
2
5
7

Possible Setups
8

Port Diagram
Optional IR
emitter cable
port
Status LED Status LED
Built-in
IR Emitter
Built-in
IR Receiver
Optional IR
receiver cable
port
9