SFS TUF-S User manual

TUF-S / TU-S / TUC-S
1.1 1.2 1.3
1. Pre-drill the panel
1.4
1.6
1.5
1.1
Use a blind-hole
drill bit
1.2
Do not use a drill bit
with a point angle
1.3
Do not use a
worn-out drill bit
1.4
Panel must lie on
a hard surface
1.6
Clean drill-hole
from dirt
1.5
Keep a right angle
during the drill
process
thickness
60
-0,1
ø
Bracket
+0,5 0Drill depth
L
6,5ø -7,0
12
≥
TUF-S Length – Bracket Thickness = TUF-S Drill depth
TU-S Length – Bracket Thickness + 0,5 mm = TU-S Drill depth
TUC-S Length – Bracket Thickness + 1,0 mm = TUC-S Drill depth
The geometry of the drill hole shall be checked minimum on 1% of all
drillings. Nominal measure: Ø 5,9 – 6,0 mm
Pre-drill using a Ø 6 mm blind-hole drill with depth stop
Life expectancy for SFS drill bits
Drill bit in HPL in fibre cement
HSS 100 – 150 drills 25 – 100 drills
VHM 500 + drills 250 – 500 drills
Drill depth tolerance: +0,5 / 0

© SFS intec, 2018 MA_TUF_11-2018 Technical changes reserved
All calculations therefore have to be checked and approved by the responsible planner ahead of execution.
The user is responsible to assure compliance with all applicable laws and regulations.
SFS intec AG
Division Construction
Rosenbergsaustrasse 20
CH-9435 Heerbrugg
constructio[email protected]
www.sfs.biz
3.1
Panel must lie on
a hard surface
3.2
Keep a right angle
during the setting
process
Push the GESIPA®
PowerBird®Pro
slightly towards
the panel
2.2
There is a gap
between the
TU-fastener head and
the bracket
2.3
Giving heavy force
to the TU-fastener
while not removeing
the mandrel can
cause damage to
the panel
thickness
60
-0,1
ø
Bracket
+0,5 0Drill depth
L
6,5ø -7,0
12
≥
2.2
3.1
2.3
3.2
2. Position the bracket
3. Remove mandrel
Position the pre-drilled bracket over the hole in the panel and push through the TU-fastener
Remove the mandrel using the GESIPA®PowerBird®Pro riveting tool combined with nose piece 17/36 or 17/40
Dimension must be kept