SGS CapHeat User manual
2. Connect the machine to power supply, turn the “power switch” on, as shown in Figure 1. (Rated voltage:
V, rated power: W)
Ⅰ. Commissioning
Figure 1
Figure 2
01
Heating plate
Adjustment hand wheel
Mould base
Figure 3
Celsius degree indicator
Setup indicator
Time indicator
Temperature
display
Time display
-
+
Power switch
1. Remove the package and cable ties, lift the pressure handle, as shown in Figure 1. Rotate the “adjustment hand
wheel” to an appropriate position of pressure, as shown in Figure 2.
Mould
Pressure handle
-
+
Fahrenheit degree indicator
Temperature setting
Time setting
3.Parameter settings
a. When the display is powered on, there will be a short beep and letter “K” will be displayed on the upper display window while the set value of temperature is
displayed on the lower display window. Then, the measured value of temperature and the set value of time will be displayed on the upper and lower windows.
b. Fahrenheit degree selection: as shown in Figure 3, the “Fahrenheit degree indicator” indicates whether the temperature is displayed in Fahrenheit degree.
Since there are a variety of ways to switching between Fahrenheit degree and Celsius degree, specific switching methods are not introduced in this user
manual. If there is any need for temperature unit swathing, please contact the distributor or the manufacturer or use the formula below: [Fahrenheit
degree= 32 + Celsius degree ×1.8; Celsius degree= (Fahrenheit degree - 32) ÷1.8)
Figure 4
c. Technological parameter setting (Celsius degree)
Operating temperature: press button “temperature setting” in the initial state, temperature indicator starts
blinking. Press “+” or “-“ to set the operating temperature. When temperature setting is completed, press “temperature
setting” again to return to the initial state.
Heating time: press button “time setting” in the initial state, time indicator will start blinking. Press “+” or “-“ to set
heating time. When heating time setting is completed, press “time setting” again to return to the initial state.
d. Reference values (these values are for reference only and can vary with different products)
Operating temperature can be set to 170℃, max temperature can be set to 180℃for 10s.
02
4. As shown in Figures 5 and 6, pull the “cap stretcher handle” following the direction of the arrow to lift the
cap stretcher. Fit the cap to be processed onto the mould, release the “cap stretcher handle”, the cap will be
flattened, as shown in Figure 7.
Figure 5
Figure 6
Cap stretcher handle
5. When the operating temperature is reached, push the “pressure handle” down until the beeper keeps
beeping, as shown in Figure 8 and 9. Then, lift the “pressure handle” and remove the cap from the mould.
Pressure handle
Figure 7
Figure 8
Figure 9
03
6. Preparations: clean up the surface of the material to be transferred, attach the transfer paper to the surface
of material to be transferred, fix it using the high temperature tape, and keep the front side of the material up.
Rotate the “adjustment hand wheel” to adjust the mould height in the event of excessive or inadequate pressure.
7. Tips for poor pattern transfer printing:
Faded color: this is caused by low temperature, uneven pressure, or short transferring time. Blurry pattern: this is
the result of over extension of ink due to excessive transferring time.
Lusterless pattern surface: this is caused by overpressure or excess temperature. Partially blurry pattern: this is
attributed to the uneven heat distribution in the heat pressing area.
Scar on the pattern: this is caused by excess heat pressing time. Different color shades: this is the result of uneven
pressure, irregularity, or uneven transfer coating.
Transfer paper adhesion: this is due to overtemperature or improper transfer coating.
