ZS364Q_QSG_MP_Mv2
For questions or to register your product, visit us online at sharkclean.com
@sharkcleaning
©2019 SharkNinja Operating LLC. APEX, DUOCLEAN, SHARK, AND ZERO-M are registered trademarks
of SharkNinja Operating LLC.
Brushroll/Soft Roller Access
1. To open the brushroll garage, slide both
release buttons on the floor nozzle away
from you, towards the back of the nozzle,
then lift o the lid.
2. To close the brushroll garage, insert
the 3 tabs on top of lid into the 3 slots in
the nozzle, then push down on both sides
of lid until it clicks securely into place. If
Brushroll Indicator Light isn’t green and
headlights are flashing, check again that
both sides of lid are locked in place.
MAINTENANCE
Brushroll Maintenance
With the garage lid removed, carefully
clear away any debris that may
be impeding the brushroll.
Cleaning the Soft Roller
Lift out the Soft Roller by pulling the tab
on the right side. Clear away any debris,
then slide the Soft Roller back into place.
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the
airway, then remove any blockages.
Empty the dust cup every time
debris reaches the MAX fill line.
Empty ZS364Q
APEX®
Corded Stick Vac
QUICK
START
GUIDE
Use this Quick Start Guide
to start using your new
vacuum’s great features.
Register your vacuum at
registeryourshark.com
For information on
additional parts
and accessories, visit
sharkaccessories.com
Please be sure to read the enclosed Shark®Owner's Guide prior to using your unit.
HAVING TROUBLE?
ISSUE
Vacuum is not picking up debris. No suction
or light suction.
Solution
Empty dust cup, clean filters, check all
openings for blockages.
ISSUE
Vacuum lifts area rugs.
Solution
Turn o the unit to disengage the brushroll
and restart with the Power button.
NOTE: If you see any hair wrapped
around the brushroll, continue cleaning,
using Setting II, Carpet, on bare floors.
This will allow Zero-M® technology to
remove the hair wrap and send it to
the dust cup.
