Shark DuoClean Powered Lift-Away AZ910UK Series User manual

AZ910UKSeries_MP_QSG_190510_MV2
For questions or to register your product, contact us at
0800 862 0453 or visit us online at sharkclean.eu
©2019 SharkNinja Operating LLC. All rights reserved. Made in China. SHARK, DUOCLEAN and LIFT-AWAY are registered trademarks
of SharkNinja Operating LLC. POWERED LIFT-AWAY is a trademark of SharkNinja Operating LLC.
QUICK
START
GUIDE
Please be sure to read the enclosed Shark instructions prior to using your vacuum
Use this Quick Start Guide
to start using your new
vacuum’s great features.
Register your vacuum at
registeryourshark.com
AZ910UK SERIES
Access brushroll and Soft Roller
1. Use a coin to unlock the 3 locks on the
bottom of the floor nozzle, a portion of
the base is removable to allow for better
access to the brush roll and exposure to
the airway. Shine a torch from the bottom
to check for possible blockage in the
airway.
2. Clear away any objects or debris.
3. To reassemble, replace base by lining it
up along the front of the nozzle. Push
down to snap into place. Lock the 3
locks. If Brushroll Indicator Light isn’t
green and headlights are flashing, check
again that both sides of lid are locked in
place.
MAINTENANCE
Empty dust cup after each use
Empty
Release
TIP:
Wash filters to keep the
suction strong.
Rinse filters and allow to air-dry
completely. Tap loose dirt
from foam filters as needed
between washes.
See enclosed instructions for
complete details on removing
and cleaning filters.
Brushroll Maintenance
Carefully remove any debris that may be
impeding the brushroll.
Soft Roller Maintenance
Lift out the Soft Roller by pulling the tab
on the right side. Clear away any debris,
then slide the Soft Roller back into place.
DUOCLEAN®
POWERED LIFT-AWAY™ WITH
ANTI HAIR WRAP TECHNOLOGY
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the
airway, then remove any blockages.
@sharkcleaninguk @sharkcleanuk @sharkcleanuk

NOTE: For best performance, use Hard Floor Setting I for all above-floor accessories.
NOTE: See below for wand and
handle release instructions.
VERSATILE FLOOR-TO-CEILING CLEANING
A Handle
B Hose
C Vacuum Pod
D Wand
E DuoClean® Floor Nozzle
F Duster Crevice Tool
G Upholstery Tool
H Pet Power Brush
(certain models only)
A
B
C
D
E
ASSEM B LY
2
(Click)
1
(Click)
3
(Click)
4
(Click)
WHAT’S INSIDE:
The top flap of your box shows the select accessories that are included with your model.
For complete instructions, see the enclosed instruction booklet.
For additional parts and accessories, visit sharkclean.eu
UPRIGHT MODE POWERED LIFT-AWAY™ MODE
ABOVE-FLOOR CLEANING IN LIFT-AWAY® MODE
Place your foot gently on the floor
nozzle and tilt the handle back. Choose
floor type and press power button.
Attach desired cleaning accessory
to wand or handle.
1. Insert wand into floor nozzle.
2. Insert handle into wand.
3. Place pod onto wand.
Slide down to connect.
4. Press hose into back of pod.
Lift-Away
Release
Press Lift-Away Release
button to lift pod off wand to
clean hard-to-reach places.
Wand
Release
Wand Release
Handle
Release
Floor Type
Power Button
Hard Floor: Gentle on hard floors.
Thick Carpet/Rug: Optimised
brushroll speed and suction for thick
carpets.
Carpet/Low Pile: Optimised brushroll
speed and suction for carpets.
F G H