Shark Navigator LIFT-AWAY PRO User manual

Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
ASSEMB LY
A Portable Lift-Away® Pod
B Floor Nozzle
C Extension Wand
D Handle with Stretch Hose
WHAT’S INSIDE FLOOR CLEANING
D
B
C
QUICK START GUIDE
E
A
F
E Accessory Holder
F Crevice Tool
G Upholstery Tool
G
1
(Click)
2
(Click)
3
(Click)
4
(Click)
Insert pod onto
motorized floor nozzle.
Connect the handle to the top of the wand, pressing
until it clicks into place. Connect hose to the back of the
pod, pressing until it clicks into place.
Insert wand into the
pod.
LIFT-AWAY ®PRO
1Plug In Vacuum
Then place your foot
gently on the floor nozzle
and tilt the handle back.
= Brushroll On
= Bare Floor
= OFF
BRUSHROLL ON/OFF:
1Press the Power/Surface switch at the top
of the pod to Setting I to vacuum bare floors
(straight suction only) or to use Lift-Away®
mode. To vacuum carpets and rugs, use
Setting II to engage the motorized brushroll.
2Step on the floor nozzle and tilt the handle back
towards you to engage the brushroll.
2Choose Setting
Slide the Power/Surface switch to the
appropriate floor setting and start cleaning.

For questions or to register your product, visit us online at sharkclean.com
©2019 LIFT-AWAY and SHARK are registered trademarks of SharkNinja Operating LLC.
NAVIGATOR is a trademark of SharkNinja Operating LLC
NV360_QSG_REV_Mv11
MAINTENANCE
Empty dust cup after each use
Turn the dust cup
upside down over
the trash and press
the top release
button. To remove
debris from the dust
screen, tap gently or
wipe with a dry cloth
as needed.
Pull up on
Dust Cup
Release latch
and lift dust cup
o pod.
Hold dust cup over
a trash bin and press
the empty-release
latch on the bottom.
Remove any string,
carpet fibers, or hair
that may be wrapped
around the brushroll.
Detach the floor nozzle
from the portable
Lift-Away pod.
Pre-Motor (foam and felt):
With the dust cup removed, take out pre-motor filters and
rinse them with water only.
Post-Motor (HEPA):
To access the HEPA filter, pull the latch under the filter
cover and lift o the cover. Remove the HEPA filter, rinse
it with water only. Let all filters air-dry completely before
reinstalling.
MAINTENANCE:
Rinse pre-motor filters
every 3 months, and
post-motor filter once
a year.
Rinse with water only,
and allow all filters
to air-dry completely
before reinstalling.
Easy brushroll maintenance
Cleaning Filters
Post-Motor
Pre-Motor
1Plug In Vacuum
Press Lift-Away button to lift
pod o floor nozzle. You are
now ready to clean those
hard-to-reach places.
2Attach desired cleaning accessory.
To clean above-floor
areas with the handle,
detach it from the
wand by pressing the
Handle button.
To clean with
a longer reach,
detach the
wand from the
floor nozzle by
pressing the
Wand Release
button.
Handle
Wand
Release
SUCTION CONTROL
Adjust the suction by rotating
the suction release collar on
the handle counterclockwise
to reduce the suction or
clockwise to increase suction.
LIFT-AWAY® MODE
Attach accessories
to handle or wand.
For additional parts
and accessories, visit
sharkaccessories.com
For additional parts and accessories, visit sharkaccessories.com