Shark NAVIGATOR LIFT-AWAY NV391 User manual

ASSEMB LY
WHAT’S INSIDE MAINTENANCE
QUICK START GUIDE
NAVIGATOR™
LIFT-AWAY®
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
Press top dust
cup release latch
to access dust
screen and remove
built-up debris
asrequired.
Pre-Motor (foam and felt):
With the dust cup removed, take out the foam and felt filters
and rinse them with water. Tap loose dirt o filters between
washes as needed.
Post-Motor (HEPA):
To access the HEPA filter, reach under the grill, pull the tab
forward and pull the grill away from the vacuum. Remove
and rinse the HEPA filter.
Empty dust cup after each use
TIP:
Wash filters every
3 months to keep
the suction strong.
Rinse filters and allow
to air-dry completely.
Tap loose dirt from
foam filters as needed
between washes.
Easy brushroll maintenance
Cleaning Filters
To remove the
dust cup, undo
the latches on the
sides by lifting
them up and
outwards.
Use a coin to open the 2
locks on the bottom of the
floornozzle.
Hold dust cup
over a trash bin
and press the
empty-release
latch on the
bottom.
Remove any string, carpet
fibers, or hair that may
be wrapped around the
brushroll.
AHandle
BMotorized Floor Nozzle
CWand
DCrevice Tool
EWide Upholstery Tool
FDusting Brush
GPet Power Brush
HMulti-Angle Dusting Brush
Foam filter
Felt filter
HEPA filter
Place the pod
onto floornozzle.
Slide accessory
holder onto
extension wand.
Insert handle into top of
wand, then attach hose
connector on back of pod.
Slide wand into
base ofpod.
1
(Click)
2
(Click)
4
(Click)
3
(Click)
A
B
C

USING YOUR VACUUM IN LIFT-AWAY® MODE
For questions or to register your product, contact us at 800-798-7398 or visit us online at sharkclean.com
@sharkcleaning
1Press Floor Nozzle
release button to lift
pod o floor nozzle.
2Press Handle release
button when you
need to clean within
short reach.
Press Extension Wand
release button on pod when
you need to clean with a
longer reach.
4Attach desired cleaning tool
to the end of handle or wand.
WARNING:
Lift-Away mode requires stable footing. Using Lift-Away mode
without stable footing may result in personal injury.
TIP:
Our Lift-Away feature allows you to remove the pod from
the floor nozzle to easily clean stairs, above-floor areas with
accessories, or hard floors with the hard-floor attachments.
NV391_QSG_170807
©2017 SharkNinja Operating LLC. LIF T-AWAY and SHARK are registered trademarks of SharkNinja
Operating LLC. DUST-AWAY and NAVIGATOR are trademarks of SharkNinja Operating LLC.
OR
D
F
H
E
G
3