Shark Navigator Lift-Away User manual

a
PORTABLE LIFT-AWAY®
1 Press handle release button to detach
handle (or handle with extension wand).
2 Press red nozzle release button (h), place
foot on nozzle and pull the canister up.
3 Attach desired tools to clean.
CARPET AND BARE FLOOR
CLEANING:
1 Attach floor nozzle (a) into the bottom
of the canister (b).
2Insert extension wand (c) into the back
of the canister, slide on the accessory
holder (d) and place the on-board tools
(e).
3 Insert handle (f) into the top of the
extension wand and connect the hose
(g) to the back of the canister.
f
e
d
g
c
b
h
QUICK START GUIDE: ASSEMBLY
Simple steps to get you cleaning with your new
Shark® Navigator® Lift-Away® Professional Vacuum.
BRUSH ROLL ON/OFF:
1Press the ON/OFF switch at the top
of the canister to the ‘I’ position to
vacuum bare floors or to use with
tools (straight suction only) or in Lift-
Away®mode or to the ‘II’ position to
engage the motorized floor brush (for
vacuuming carpets and rugs).
2Press the floor nozzle down with your
foot and tilt the handle back towards
you to engage the brushroll.
= Brush Roll ON
= Bare Floor
= OFF
UV540_QSG_160331
TOLL FREE: 1-800-798-7398 sharkclean.com
Please make sure to read the enclosed Information Booklet prior to using your unit.

EMPTYING THE DUST CUP
1 Pull up the latches on the sides of the
dust cup to release.
2 Hold the dust cup over a trash
receptacle and press the bottom door
release button.
3 If needed, turn the dust cup upside
down over the trash and press the top
door release button.
SUCTION CONTROL
The suction can be adjusted to make the
vacuum easier to push and pull on certain
types of carpets as needed.
Adjust the amount of suction by rotating
the suction release collar on the handle
counterclockwise to reduce the suction or
clockwise for maximum suction.
INDICATOR LIGHT
The motorized brush indicator light will
illuminate Green when motorized floor
brush is on. If there is a blockage or jam,
the light will turn Red (see page 9 of the
instruction manual).
IMPORTANT: Loss of Suction may occur if foam lters are not cleaned every
3 months. Rinse and allow to air dry completely. Also, tap loose dirt off lter
between washes as needed.Foam lters may appear dirty after use - this is
normal. Please refer to the maintenance section of the manual for instructions
on cleaning the lters.
CLEANING FILTERS
1 With the dust cup removed, pull the
2 filters out from the top of the motor
base.
2 Rinse the filters thoroughly in lukewarm
water until the water runs clear.
3 Squeeze out excess water and let
air-dry for at least 24 hours before
inserting back into the vacuum.
Pre-Motor
Foam Filter
Felt Filter
QUICK START GUIDE: USE AND CARE
Please make sure to read the enclosed Information Booklet prior to using your unit.
TOLL FREE: 1-800-798-7398 sharkclean.com