Shark QU202Q User manual

with Shark® Self-Cleaning Brushroll
QU202Q Series
QUICK
START
GUIDE
Use this Quick Start Guide
to learn about your new
vacuum’s great features.
Please be sure to read the enclosed Shark®Owner's Guide prior to using your unit.
To register your product, or for answers to frequently asked questions, visit registeryourshark.com.
© 2020 SharkNinja Operating LLC. DUOCLEAN and SHARK are registered trademarks of SharkNinja Operating LLC.
QU202Q_QSG_MP_Mv2
Cleaning the Brushroll
1. To open the brushroll garage, slide both
release buttons on the floor nozzle away
from you, towards the back of the nozzle,
then lift o the lid.
2. Clear away any objects or debris.
3. To close the brushroll garage, insert
the 3 tabs on top of the lid into the 3 slots
in the nozzle, then push down on both sides
of the lid until it clicks securely into place. If
the Brushroll Indicator Light isn’t green and
headlights are flashing, check again that
both sides of the lid are locked in place.
MAINTENANCE
Filter Maintenance
Wash filters regularly to keep
the suction strong.
Rinse filters with water only, and
allow them to air-dry before
reinstalling. Tap loose dirt from
filters as needed between
washes.
See enclosed Owner’s Guide
for complete details on
removing and cleaning filters.
Brushroll Maintenance
Carefully remove any debris that may be
impeding the brushroll.
Cleaning the Soft Roller
Lift out the Soft Roller by pulling the tab
on the right side. Clear away any debris,
then slide the Soft Roller back into place.
Empty dust cup after each use
Empty
Release
SLIM UPRIGHT
Self-Cleaning Brushroll
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow
the self-cleaning brushroll to remove it for you.

For additional parts and accessories,
visit sharkaccessories.com
For complete instructions,
see the enclosed Owner's Guide.
2 WAYS TO CLEAN:
1
UPRIGHT
2
ABOVE THE
FLOOR
Power
Push the POWER button to turn
the vacuum on or o.
Brushroll Operation
To engage the brushrolls, turn
on the power, step on the floor
nozzle, and tilt the handle back.
To clean carpeted floors, press
CARPET on the surface selector
switch. The brushrolls spin
quickly in this mode.
To clean bare floors, press
HARD FLOOR on the surface
selector switch. The brushrolls
will spin slowly in this mode.
Attach any of the
specialized cleaning
accessories to the
handle or wand.
Wand
Release
Suction
Control
Handle
Release
ASSEM B LYWHAT’S INSIDE:
Place pod onto motorized floor nozzle.
Insert wand into top of pod.
Insert handle into top of wand.
Connect hose to back of pod.
Store accessories on the posts
on the pod.
F
A
B
C
D
E
G H I
AHandle
BHose
CVacuum Pod
DWand
EDuoClean® Floor Nozzle
with Self-Cleaning Brushroll
FDusting Brush
GCrevice Tool
HUpholstery Tool
IPet Power Brush
1
2
3
4
5
2
3
4
5
1
(Click)
(Click)
(Click)
(Click)