Shark ROCKET UZ345H User manual

QUICK
START
GUIDE
Please make sure to read the enclosed Shark®Owner’s Guide prior to using your vacuum.
UZ345H_QSG_MP_Mv4
EMPTYING THE DUST CUP
1. To empty the dust cup,
first disconnect the
handheld vacuum from
the wand by pressing
the Wand Release
button and pulling
up on the handheld
vacuum.
Wand Release
Button
CleanTouch
Dirt Ejector
UZ345H
POWERFINS CORDLESS VACUUM
For questions, visit us online
at sharkclean.com/support
Register your vacuum at
registeryourshark.com
ROCKET®
VERSATILE CLEANING
Slide the power button
to the desired power
setting. Place your foot
on the floor nozzle
and tilt the handheld
vacuum back.
To detach the wand for
above-floor cleaning, stand
the vacuum upright, then
press the Nozzle Release
button on the bottom of the
wand and pull the wand up
to disconnect it.
To detach the handheld
vacuum, press the Wand
Release button and lift the
handheld vacuum o the
wand.
Attach a cleaning accessory,
then choose the power setting.
NOTE: Brushroll will only engage
when the handle is tilted back.
OR
THEN
2. Position the dust
cup over a trash
bin and slide the
CleanTouch™ Dirt
Ejector forward.
© 2020 SharkNinja Operating LLC. ROCKET and SHARK are registered trademarks of SharkNinja
Operating LLC. CLEANTOUCH is a trademark of SharkNinja Operating LLC.

WHAT’S INSIDE: POWER SETTINGSASSEM B LY
For complete maintenance instructions, see the enclosed Owner's Guide.
For additional parts and accessories, visit sharkaccessories.com.
For additional batteries and charging accessories, visit sharkclean.com/batteries.
A
B
C
2
(Click)
1
(Click)
OFF BARE FLOOR
SETTING CARPET SETTING BOOST MODE
Slide switch to the
top to turn o power.
To begin vacuuming
in Standard Mode,
slide switch to the
appropriate setting.
Bare Floor/Area Rugs
Slide switch to the
middle. The brushroll
spins slowly to clean
bare floors and small
arearugs.
Carpet
Slide switch to the
bottom. The brushroll
spins faster to pick up
debris below the surface
ofyour carpets.
For an added boost in
power, pull the Trigger
on the handheld
vacuum. Release it
to return to standard
power.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the
trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
© 2020 SharkNinja Operating LLC.
AHandheld Vacuum
BPowerFins Floor Nozzle
CWand w/Handheld Storage Clip
DCrevice Tool
EDusting Brush
FCharger
GHEPA Post-Motor Filter (Pre-Installed)
E FD
D
LI-ION BATTERY
In Use
Full
Charge
Mid
Charge
Low
Charge
Nearly
Empty
No
Charge
Charging
Low
Charge
Mid
Charge
Nearly
Full
Full
Charge
NOTE: Full charge takes approximately 3 hours.
CHARGING
To charge, remove the handheld vacuum from the wand by
pressing the Wand Release button and pulling up. Plug the
charger into the charging port.
Battery Indicator Lights
Battery Runtime
MODE MINUTES
Hand Vac 40
Bare Floor/
Standard Mode 25
Carpet Mode/
Standard Mode 20
Boost Mode
(Hand Vac) 10
NOTE: The battery comes
partially charged. Charge fully
before first use.