Shark Rotator Pet Plus NV255 User manual

Remove dust cup to access foam
and felt filters. Next, press down
top of filter door. Tilt filter door
and lift out. Press tab at top of
HEPA filter and pull away from
the base of the vacuum.
To reinstall, insert HEPA filter into
unit and replace the filter door.
Wash filters every 3 months to keep the suction strong.
Rinse filters with water only and allow to air-dry completely.
Tap loose dirt from foam filters as needed between washes.
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
ASSEMB LY
AVacuum Pod
BHandle & Hose
CWand
DHose Clip
E5.5" Crevice Tool
FPet Power Brush
WHAT’S INSIDE EMPTYING THE DUST CUP
MAINTENANCE
QUICK START GUIDE
Empty the dust cup after each use.
clean
A
B
C
F
D
E
Brushroll access
Unlock Open Cover Clear Intake
Use a coin to turn locks, then lift
cover open. Clear the debris intake.
(Click)
(Click)
(Click)
(Click)
NOTE: For proper operation, ensure all parts
are firmly CLICKED into place.
HEPA
Filter
Filter
Door Foam
Felt
NV255_QSG_MP_Mv7
PET PLUS

2 WAYS TO CLEAN
FLOOR CLEANING
ABOVE-FLOOR CLEANING
For questions or to register your product, visit us online at sharkclean.com
@sharkcleaning
OR
Attach desired
cleaning accessory
to handle or wand.
For additional parts and accessories, visit, sharkaccessories.com
OR
To clean above-floor areas, remove the
handle from the wand. Or for the more
reach, remove the wand from the pod.
1
1 2
2 3
© 2019 SharkNinja Operating LLC
SUCTION CONTROL
Adjust your suction depending
on your floor type.
MIN: to reduce suction and increase
maneuverability on carpets.
MAX: to increase suction on bare floors.
HARD FLOOR
Press switch to I for
hard floor surfaces.
CARPET
Press switch to II
for low and high pile
carpet cleaning.
To engage brushroll, step on floor
nozzle and tilt handle back.