SharkNinja Operating Rocket User manual

Please be sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
ASSE MBLY
AHandheld Vacuum
BZero-M® Cleaner Head
CWand
D12˝ Crevice Tool
EPet Multi-Tool
WHAT’S INSIDE VERSATILE FLOOR-TO-CEILING CLEANING
ZS341_QSG_EB1_Mv6
AD E
B
C
QUICK START GUIDE
Corded Ultra-Light Vacuum
Rocket®
(Click)
(Click)
1 2
Settings
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in
carpets) please use Setting II, Carpet.
Slide switch to
the bottom to
turn o power. To
begin vacuuming,
slide switch to
the appropriate
setting.
Bare Floor/Small
Area Rugs
The brushrolls
spin slowly to
clean bare floors
and delicate
arearugs.
Carpet
The brushrolls
spin faster to pick
up debris below
the surface ofyour
carpets.
OFF SETTING I SETTING II
NOTE: All accessories are compatible with both the wand and the
handheld vacuum. Use Setting I for all above-floor accessories.
Stand the vacuum upright.
Step on the foot pedal on
the bottom left side of the
floor nozzle and pull the
wand up to disconnect
it. Great for cleaning
baseboards, ceiling fans,
window sills, etc.
Press the WAND RELEASE
button and lift the handheld
vacuum o the wand. Great
for cleaning stairs and
furniture.
Above-Floor
with Wand
Above-Floor
with Handheld
Upright Mode
To clean floors, place foot on floor
nozzle and tilt handheld vacuum back.
NOTE: Select Carpet for stuck-on dust and debris.

STORAGE
Hang the handheld vacuum on the hook on the bottom of
the wand, and wrap the power cord around the cord hooks.
Onboard Hook
For questions or to register your product, visit us online at sharkclean.com
@sharkcleaning
©2019 SharkNinja Operating LLC.
NOTE: If you see any hair wrapped around the brushroll, continue
cleaning, using Setting II, Carpet, on bare floors. This will allow
Zero-M® technology to remove the hair wrap and send it to the
dust cup.
MAINTENANCE
DUST CUP
Brushroll Maintenance
With the garage lid removed, carefully clear away any
debris that may be impeding the brushroll.
Checking the Nozzle for Blockages
Tilt neck of nozzle back to straighten the airway, then
remove any blockages.
Brushroll/Soft Roller Access
1. To open the brushroll garage, slide both release buttons
on the floor nozzle away from you, towards the back of the
nozzle, then lift o the lid.
2. To close the brushroll garage, insert the 3 tabs on top of
lid into the 3 slots in the nozzle, then push down on both
sides of lid until it clicks securely into place. If Brushroll
Indicator Light isn’t green and headlights are flashing,
check again that both sides of lid are locked in place.
Cleaning the Soft Roller
Lift out the Soft Roller by pulling the tab on the right
side. Clear away any debris, then slide the Soft Roller
back into place.
Empty dust cup every time debris reaches the MAX fill line.
Empty
Dust Cup
Release
With the dust cup
attached to the
handheld vacuum, press
the Empty button on the
front of the dust cup.
To remove the dust
cup from the handheld
vacuum, squeeze the
two Dust Cup Release
buttons at the same
time and pull out the
dust cup. Press the
Empty button on the
front of the dust cup.