SharkNinja Operating POWERED Lift-Away User manual

ASSEMB LY
WHAT’S INSIDE MAINTENANCE
QUICK START GUIDE
POWERED
LIF T-AWAY®
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
Insert wand into
motorized floor nozzle.
Press top dust
cup release latch
to access dust
screen and remove
built-up debris
asrequired.
Use a coin to
open the 3 locks
on the bottom of
the floornozzle.
Remove any string,
carpet fibers, or
hair that may be
wrapped around
the brushroll.
When finished,
shut the lid, then
close the 3 locks.
Lift the hinged
lid to access
brushrolls.
Pre-Motor (foam and felt):
With the dust cup removed, take out the foam and felt
filters and rinse them with water.
Post-Motor (HEPA):
To access the HEPA filter, reach under the grill and pull the
latch to remove the grill. Remove and rinse the HEPA filter.
Place pod onto wand and
slide down to connect.
Connect hose to back of
pod, pressing until it clicks
into place. Store accessories
on the posts on the pod.
Insert handle into wand.
1
(Click)
2
(Click)
3
(Click) 4
(Click)
Empty dust cup after each use
TIP:
Wash filters every
3 months to keep
the suction strong.
Rinse filters with
water only and allow
them to air-dry
completely. Tap loose
dirt from foam filters
as needed between
washes.
Easy brushroll maintenance
Cleaning Filters
Pull up on
dust cup
release latch
and lift dust
cup o pod.
Hold dust cup over a
trash bin and press the
empty-release latch
on the bottom.
HEPA
Felt filter
Foam filter
Filter
Filter Access
AMotorized Floor Nozzle
BWand
CHandle
DCrevice Tool
EUpholstery Tool
FTruePet®Mini Motorized Brush
C
B
A
FD E

VERSATILE FLOOR-TO-CEILING CLEANING
2Choose Setting
Slide the power switch to the appropriate
floor setting and start cleaning.
1Plug In Vacuum
To start cleaning, step
gently on the floor nozzle
and tilt the handle back.
FLOOR CLEANING POWERED LIFT-AWAY®MODE
LIFT-AWAY®ABOVE-FLOOR CLEANING
NOTE:
For deep cleaning per ASTM F 608 (embedded dirt in carpets) please set to Carpet/Low Pile and Suction Control to MAX.
Carpet and
Low-Pile Cleaning
Set floor selector
to Carpet/Low Pile.
Thick Carpet & Area
Rug Cleaning
Set floor selector
to Thick Carpet/
Area Rug.
Hard-Floor Cleaning
Set floor selector to
Hard Floor.
Press Lift-Away button to lift pod o floor nozzle. You
are now ready to clean those hard-to-reach places.
To clean above-floor
areas with the handle,
detach it from the
wand by pressing the
Handle button.
L
i
f
t
A
w
a
y
®
To clean with a
longer reach,
detach the
wand from the
floor nozzle by
pressing the
Wand Release
button.
Handle
Wand
Release
Attach any of the
specialized cleaning
accessories to the
handle or wand.
For questions or to register your product, visit us online at sharkclean.com
@sharkcleaning
©2019 SharkNinja Operating LLC. TRUEPET, LIFT-AWAY, POWERED LIFT-AWAY,
and SHARK are registered trademarks of SharkNinja Operating LLC.
NV752_QSG_Rev1_Mv2