- 3 -
ADJUSTING THE EXPOSURE (BRIGHTNESS)
SCANNING A 35MM SLIDE OR 35MM NEGATIVE
POWER SAVING MODE
PLAYBACK MODE
The exposure value (“EV” or brightness) is set automatically. However, there may be times when you
wish to make a photo lighter or darker.
1. Press the EV/Delete button to adjust exposure value.
1. Press UP or DOWN button to adjust the exposure compensation from +2EV to -2EV in 0.5
increments. The amount of compensation is shown at the bottom of the LCD screen.
1. Press the EV/Delete button again to complete the setting.
1. Place your slide or negative into the appropriate media holder.
(Keep the glossy surface of your film in the upward direction.)
2. Close the holder.
3. Slide the Photo/Film Focus Switch to “FILM.”
4. Slide the Photo/Film Light Switch to “FILM.”
5. Insert the loaded media holder properly into the slot,
accordingto the ∏ or ¬ sign shown on the scanner and media holder. (The holder can be inserted
into either the left or the right opening.) TIP: Keep your picture in the rectangular white frame
shown on the LCD screen. Improper adjustment may copy the black edges of the film holder. If
the black edge of a slide film is on top or bottom of the LCD screen, tilt the scanner forward or
backward to eliminate the black edge.
6. Select film type by pressing the Film Type button:
• 135 positive (slide)
• 135 negative film
• 135 black & white negative film
TIP: To get the best digitized image, wait for the image display on the LCD screen to adjust the
brightness and become stable. It normally takes 3-4 seconds, depending on the brightness of
your film. NOTE: Improper film selection will give you improper color results.
7. Press the OK button to scan the picture. The scanned digital image will automatically store on
your SD card.
8. To adjust the exposure value (brightness), follow the same steps as above.
• To conserve power, the scanner will automatically go into sleep mode if you do not use it for
more than 3 minutes. You may wake up the scanner by pressing any button.
• If the scanner is not used for more than 6 minutes, it will turn off automatically. Press the Power
button to restart the device.
1. Press the Playback button to playback the digital images saved on your card. You will see the
playback icon in the lower left hand corner.
2. Press the UP button to forward reviewing.
3. Press the DOWN button for backward reviewing.
