Sigma Glow-01 User manual

Installation Instruction
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
1. To prevent personal injury or product damage only licensed electricians should install.
2. To avoid electrical shock or component damage, disconnect power before attempting installation or servicing.
3. This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric
codes and safety standards.
4. Disconnect product and allow cooling prior to any further steps.
5. Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage
and/or product malfunction.
6. To prevent product malfunction and/or electrical shock this product must be properly grounded.
7. This luminaire is designed to operate in ambient temperatures ranging from -25°C to 40°C and to be horizontally mounted with the
LED board facing downward.
Surface-mounted with J-BOX
1. Loosen the screw on the
side of the housing and pull
out the connecting plate
2. Fix the connecting plate
onto the ceiling and put
the wire through center
hole
3. Buckle the connecting plate
into the clips and connect
the wires as following shows
Black Line
White Neutral
Green/Yellow Ground
4. Slide lamp back into the
connecting plate and fix
the screw that is removed
in step one
Pendent Installation with 3/4 inch conduit
1. Loosen the screw on the side of the
housing and pull out the connecting
plate,
2. connect the wires as following shows,
Line
Neutral
Green/Yellow Ground
Black
White
3. Screw the lamp and conduit pole
together tightly
Parking Garage Fixture

Sensor set-up
Surface-mounted with side-wiring
1. Remove the lens and metal cover in
the middle
2, Cut off wires coming out of 3/4” hole
and seal the hole with provided plug.
Drill 4 holes on four corners and fix it
onto the ceiling with suitable screws
3. Remove 1/2” plug against the
direction you intend to connect the
conduit
4. Relocate the wire from 3/4” hole to 1/2” hole and connect
to the conduit as following
Line
Neutral
Green/Yellow Ground
Black
White
5. Put back the middle metal cover and lens, make sure no
wires are pinched or exposed during the whole process
1. Remove the lens
2. Adjust the combination of DIP switches
with appropriate tool according to needs
3. Put back the lens and check the
function of sensor