Signature Hardware Keswick 923164 User manual

KESWICK FREESTANDING FAUCET INSTALLATION
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing fixtures. Signature
Hardware accepts no liability for any damage to the
plumbing, floor, walls, tub, or for personal injury during
installation.
Observe all local plumbing and building codes.
Unpack and inspect the faucet for shipping damage. If
any damage is found, contact our Customer Relations
team at 1-866-855-2284.
*not included
Ensure that you have gathered all the required
materials that are needed for the installation.
For these instructions, it is assumed that the floor has
been finished and the water supply has been
prepared.
TOOLS AND MATERIALS:
Plumbers
Tape*
Thread
Sealant*
Adjustable
Wrench*
1Keswick Freestanding Faucet Installation Instructions
Masking Tape
Level Hex Wrench
Drill Wood Shims Pencil or
Marker
SKU(s): 923164

KESWICK FREESTANDING FAUCET INSTALLATION
Installation
3. Slide the decorative baseplate onto the faucet body,
as shown.
4. Attach the mounting bracket by threading it onto the
base of the faucet. Hand tighten firmly. Position the
faucet at its desired location, then mark the location of
the mounting holes on the floor. Set the faucet aside.
1. Connect the provided braided water lines to the
supply posts on the faucet’s spout. Apply thread
sealant or plumber’s tape to the threads before
tightening. Hand tighten the connections firmly.
Tip: Place a piece of masking tape on the bottom of
the hot water line. This will prevent the hot and cold
lines from being crossed when it is time to connect to
the main water supplies.
2. Feed the water lines through the faucet body and
attach the spout by threading it onto the body.
2Keswick Freestanding Faucet Installation Instructions

KESWICK FREESTANDING FAUCET INSTALLATION
7. Connect the braided water lines to the main water
supply at the floor. Ensure that you are connecting the
hot and cold lines accordingly. Apply thread sealant or
plumber’s tape to the threads before attaching. Hand
tighten firmly, then finish tightening using an adjustable
wrench. Be careful not to overtighten.
8. Briefly turn on the main water supply to ensure that
there are no leaks. Once you have determined that
there are no leaks, turn the water supply back off and
continue with the installation.
5. Drill pilot holes into the floor at the marked mounting
hole locations. The pilot holes should measure approxi-
mately 1” deep and ¼” in diameter.
6. Remove the nuts, locking washers, and metal
washer from each of the mounting screws. Drop each
of the screws and anchors into the drilled pilot holes,
with the threads facing up through the floor.
3Keswick Freestanding Faucet Installation Instructions
1”
Threading Facing Up
ON
OFF

KESWICK FREESTANDING FAUCET INSTALLATION
11. Once installation is complete, turn on the main
water supply. Remove the aerator from the spout and
turn the faucet on. Allow the water to flow for 60
seconds to remove any dust or loose sediment within
the water lines. Check for any leaks, and that hot and
cold water are running appropriately. Divert the water to
the hand shower and allow the water to flow through
the hose for approximately 60 seconds.
9. Secure the faucet to the floor using the metal
washers, locking washers, and nuts that were removed
in step 6. Slide the decorative baseplate to the floor to
conceal the mounting hardware and rough-in.
10. Finish your installation by attaching the hand
shower to the faucet using the hand shower hose.
Hand tighten each connection firmly.
4Keswick Freestanding Faucet Installation Instructions
ON