Signature Hardware Rotunda User manual

1Rotunda Wall-Mount Faucet Installation Instructions
ROTUNDA WALL-MOUNT FAUCET
INSTALLATION INSTRUCTIONS
Before installing, read entire Rotunda Wall-Mount Faucet Installation Instructions. Observe all local building and safety
codes.
For the following installation instructions for your new wall-mount faucet it is assumed that any old xtures have been
removed and the water supply lines have been relocated to the proper installation location.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1-866-855-2284. If you need assistance or have questions while installing your wall-mount faucet, contact
Customer Service.
We recommend consulting a professional if you are unfamiliar with installing bathroom xtures. Signature Hardware
accepts no liability for any damage to the oor, walls, plumbing or for personal injury during installation.
TOOLS AND MATERIALS
INSTALLATION DIAGRAM
Allen Wrench (provided) LevelDrill
Wood Screws Silicone Sealant
Finished Wall
Plastic RingStop ScrewCoreEscutcheon
Handle Body
Locking Screw
Handle
Wall Anchor
M6 ScrewSpout Joint
Self-tapping
ScrewValve Body Spout
Spout
Escutcheon
1-1/4"-2-1/4"
Cold Water InletHot Water Inlet

2Rotunda Wall-Mount Faucet Installation Instructions
INSTALLATION
1. Remove the handle, locking screw, handle body, plastic spacing ring, stop screw and core from the faucet body. Put
the plastic faucet protector on the faucet body.
2. Install the faucet body behind the nished wall in accordance with installation diagram. Wrap Teon tape around the
threaded connections and attach to the water supplies.
3. Plug the outlet on the faucet body and turn on the water supply to verify that there is no leakage.
4. Finish the wall or tile around the faucet body.
5. Wrap the Teon tape around the spout joint and connect it with valve body. Push the spout escutcheon in place close
to the wall, connect the spout, and tighten it with an M6 screw.
6. Remove the plastic faucet protector, and nish faucet assembly as specied in diagram.
7. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight
(no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow
the water to ow through the spout for approximately 60 seconds. Allow any sealant to cure for 24 hours before use.