Signature Hardware ROTUNDA User manual

1Rotunda Widespread Faucet Installation Instructions
ROTUNDA WIDESPREAD FAUCET
INSTALLATION INSTRUCTIONS
Before installing, read entire Rotunda Widespread Faucet Installation
Instructions. Observe all local building and safety codes.
For the following installation instructions for your new widespread
faucet it is assumed that any old xtures have been removed and any
repairs or modications to the water supply have been completed.
Unpack and inspect the product for any shipping damages. If you nd
damages, do not install. Contact Customer Service at
1-866-855-2284. If you need assistance or have questions while
installing your faucet, contact Customer Service.
We recommend consulting a professional if you are unfamiliar with
installing bathroom xtures. Signature Hardware accepts no liability for
any damage to the oor, walls, plumbing or for personal injury during
installation.
TOOLS AND MATERIALS:
INSTALLATION
Adjustable Wrench Basin Wrench
4" 4"
1-1/4"
1-1/2"
1-1/4"
1/2"1/2"
1-1/4" min
1. Loosen the M4 screwsto remove handle levers, handle
escutcheonsand base plates. Move the locking nut
down on the threaded portion of the handle valves.
2. From beneath the sink, feed the handle valves
through the vanity top. Thread the base plates
and handle escutcheonsonto the valves.
M4 Screw
Handle Lever
Handle Escutcheon
Base Plate
Rubber Washer
Handle Valve
Locking Nut
Vanity Top

2Rotunda Widespread Faucet Installation Instructions
3. Remove the protective sheath, double-wedge nut, locking washer and rubber washer from the faucet body. Repeat
the previous steps to secure the faucet body.
Faucet Body
Locking Nut
Rubber Washer
Base Plate
Protective Sheath
Double-wedge Nut
4. Hand tighten to attach the hot and cold exible water feed tubes to the handle bodies and brass T. Give a ¼ turn with
pliers or wrench, but don’t over tighten. Curve tubes as necessary to ensure there are no kinks or knots.
5. Connect the main water supply to the faucet body.
6. To install the new pop-up drain, apply a bead of silicone sealant to the underside of the drain ange and place in the
mounting hole. If there is no pop-up drain, move on to step 16.
7. Thread the lock nut onto the drain pipe and tighten with your adjustable wrench.
8. Wipe away any excess sealant around the drain using your damp cloth.
9. Push the pop-up rod down through the faucet body. Attach the pop-up rod to the pivot rod with the extension rod.
Adjust the rods so that the drain stopper opens and closes properly.
10. Attach the P trap to the drain pipe and wall drain tting and tighten the lock nuts.
11. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight
(no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow the
water to ow through the spout for approximately 60 seconds.