Signature Hardware BOLAND User manual

1Boland Water Dispenser Installation Instructions
BOLAND WATER DISPENSER INSTALLATION
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing fixtures. Signature
Hardware accepts no liability for any damage to the
faucet, plumbing, sink, counter top, or for personal injury
during installation.
Observe all local plumbing and building codes.
Unpack and inspect the faucet for shipping damage. If
any damage is found, contact our Customer Relations
team at 1-866-855-2284.
Note: Make sure to winterize your outdoor faucet
before cold weather arrives to prevent burst pipes and
protect the faucet’s hardware.
TOOLS AND MATERIALS:
GETTING STARTED
Ensure that you have gathered all the required
materials that are needed for the installation.
For these instructions, it is assumed that the old
faucet has been completely removed and any
necessary repairs or modifications to the water
supply have been completed.
Plumbers
Tape
Thread
Sealant
Adjustable
Wrench
Small
Bucket
Basin
Wrench
SKU(s): 433110, 433136

Boland Water Dispenser Installation Instructions
BOLAND WATER DISPENSER INSTALLATION
2
INSTALLATION
2. Remove the lock nut, rubber washer, and metal
washer from the faucet body. 4. From beneath the sink, slide the rubber washer and
metal washer back onto the faucet body. Thread the
lock nut back onto the shank and tighten firmly using a
basin wrench.
3. Attach the flexible water line to the base of the
faucet. Apply thread sealant or plumber’s tape to the
threads before attaching. Insert the faucet into its
prepared mounting hole.
1. Ensure that the water supply below your sink is
completely shut off by turning the shutoff valves all the
way to the right.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
OFF

6. Once installation is complete, turn the main water
supply back on from underneath your sink. Check for
any leaks underneath.
7. Remove the aerator from the spout. Turn the faucet
on and allow the water to flow for approximately 60
seconds. Ensure that there are no leaks. Reattach the
aerator.
5. Apply plumber’s tape or thread sealant to the
threading of the faucet’s water line, and connect to
the main water supply.
Boland Water Dispenser Installation Instructions
BOLAND WATER DISPENSER INSTALLATION
3
ON