7
CONTROL PANEL
1. Timer Dial
2. Cool Air Setting
3. Oscillation Control
4. High Speed Setting
5. Medium Speed Setting
6. Low Speed Setting
7. Stop Button
USING YOUR APPLIANCE:
To turning the Appliance On and O
1. Rotate the dial to the ‘1’ position to turn
the air cooler on.
2. Rotate the dial to the ‘0’ position to power
down the air cooler
THE TIMER FUNCTION:
Rotate the timer dial to the ‘60’ or ‘120’
position when the cooler is in operation to
activate the 60 or 120-minute timer function.
Your air cooler will then automatically operate
for the specied period of time.
DIRECTING THE AIR FLOW:
You can manually direct the air ow at any time
by raising or lowering the two vanes at the front
of the ventilation grill. Raising these vanes will
direct the airow upwards, while lowering them
will direct it downwards.
THE OSCILLATION FUNCTION:
To activate the oscillation function, press
the ‘WIND’ button when the air cooler is in
operation. The air cooler will then automatically
oscillate until the air cooler is powered down
THE COOL AIR FUNCTION:
To activate the cool air function, press the
‘COOL’ button when the air cooler is in
operation.
NOTE: Make sure to add clean water to the
tank before using the cool air function. Ensure
the drain plug is sealed tightly and that water
does not spill into the motor or any other
electrical components, as this could cause
damage to the product. Take care not to ll the
tank above the recommended level, to prevent
overow.
SETTING YOUR DESIRED SPEED:
To select your preferred speed setting, press
the relevant button when the air cooler is in
operation.
• For Low speed, press the ‘LO’ button.
• For Medium speed, press the ‘MI’ button.
• For High speed, press the ‘HI’ button
To cancel your selection, press the ‘STOP’
button at any time when the cooler is in
operation.
AIR PURIFICATION FUNCTION:
This air cooler is equipped with an air
purication function. This function automatically
activates whenever the cooler is in operation.
TIPS:
1. Do not obstruct the air outlet when
operating the unit.
2. Use indoor only.
3. The unit is safe and reliable as long as the
power socket is earthed.
4. Clean the lter every 20-30 days for
optimum performance.
5. Always ensure that there is water in the
unit when in use, for cooling.
6. If the supply cord is damaged, please
contact your supplier for help.
NOTE: The included ice packs can be used
to create an even cooler wind when using the
humidifying function. To make use of the chilled
air function, put the two ice packs included
with the unit into the bottom drawer of a freezer
and leave them overnight, so that the water
inside turns into ice. Once the ice packs are
fully frozen, take them out of the freezer and
insert them into the smallest compartment
inside the water tank. When each pack is
secured inside the compartment, close the
water tank, turn the unit on and press the
Humidier/Cold wind button to activate the
humidifying function. The unit will now operate
as normal.
1 2 3 4 5 6 7
