Sigtronics SEH-2S User manual

igtronics
®
S
igtronics
®
S
…when it counts!
Model SEH-2S
Headphone Instructions
The SEH-2S series of headphones are adjusted at the factory for imme-
diate use with all Sigtronics emergency apparatus intercoms and radio
adapters in emergency vehicles. The headphone is equipped with a
single plug and a coiled cord.
The head strap is adjustable so you may custom t the headphone.
Place the headphone over your head and adjust the strap until mini-
mum pressure is felt on the top of your head. For maximum noise
attenuation, the clamping pressure of the headband has been set at
the factory. Releasing the clamping pressure by bending the head-
band is not advised, because loss of attenuation will result.
When you rst connect the headphone, turn the volume control on
the headphone up to the full clockwise position, then adjust the lis-
tening volume with the audio control of either your radio or intercom
as appropriate. If applicable, crew members should also turn their
individual headphone volumes up fully. Doing this allows for a full
range of adjustment for each passenger, since those with the most
acute hearing can turn their headphone volume down, if necessary.
continued on back…
The headphone parts may be cleaned with mild soap and water using
a soft cloth. Then dry immediately. Caution: Do Not immerse any part
of the headphone in water or any other liquid. Exposure to moisture
may cause internal corrosion and failure and will void your manufac-
turers warranty.
Cleaning will help the headphone maintain its “like new” condition
for many years.
WARRANTY
Your headphone is covered by a limited two-year parts and labor
warranty. Please see the enclosed warranty card for details.
You may refer to the parts list on the reverse side, if you choose to
replace parts yourself. The parts list describes parts for this particular
headphone only. Parts lists for other models are available on our Web
Site or can be obtained by contacting Sigtronics Corporation.
Sigtronics Corporation
178 East Arrow Highway
San Dimas, CA 91773
Phone: [phone]
E-mail: [e-mail]
Web Site: www.sigtronics.com
























SIGTRONICS SEH-2S HEADPHONE PARTS IDENTIFICATION BREAKDOWN
ITEM P/N DESCRIPTION ITEM P/N DESCRIPTION ITEM P/N DESCRIPTION
1100567 GROMMET, SE-2 STUD 8100568 STRAIN RELIEF, CABLE 15 100409 EAR CUP, PRINTED AND DRILLED, MIC & NON MIC SIDE
2100063 KNOB, 3/8 INCH, BLACK, VOLUME 9100369 EAR SEAL, FOAM FILLED 16 10 0 411 STRAP, HEADSET, SE-2, BLACK
3100077 POTENTIOMETER 10 800035 CABLE, HEADSET, STEREO, COILED 17 800220 HEADBAND, METAL, BLACK, WITH GROMMETS, SE-2
4100858 RECEIVER AND MOUNT, 300 OHM, MONO 11 100684 FOAM, SOUND ATTENUATING, FOR SLOTTED EAR CUP ONLY 18 100413 HEADBAND EXTRUSION, 4 IN., SE-2
5100108 SCREW, 4-40 X 1/4, THREAD FORMING 12 100374 FOAM, SOUND ATTENUATING. NOTCHED, 1/2 INCH 19 100451 STUD, SE-2, EAR CUP TO BAND MOUNT
6100221 WIRE, #22, 19 STRAND, 4 INCH 13 100376 FOAM, SOUND ATTENUATING. RECEIVER HOLE, 1/2 INCH 20 100675 OPTIONAL – HEADBAND, METAL, BLACK, LARGE
7100252 NUT, HEX, 8-32, LOCKING 14 100379 FOAM, SOUND ATTENUATING, RECEIVER COVER, 1/4 INCH 21 100402 OPTIONAL – EAR SEAL, GEL FILLED
8-18-2015
seh-2s.pdf