SilverBack IDBHS1 User manual

IDST (Silverback) Charger
User Guide

Part No: IDST Charger Manual v2.1 1
Table of Contents
Thank You....................................................................................................................................... 2
Charge the Battery ......................................................................................................................... 2
Battery Charging............................................................................................................................. 2
Operating and Cleaning Maintenance........................................................................................... 3
Troubleshooting ............................................................................................................................. 4
Battery Safety Guidelines .............................................................................................................. 4
Warranty and Customer Support .................................................................................................. 4
Safety and Regulatory Information............................................................................................... 4

Part No: IDST Charger Manual v2.1 2
Thank You
We appreciate your choice of the IDBHS 2-Bay Charger (P/N IDCH-BHS1-2) and/or 10-Bay Charger (P/N
IDCH-BHS1-10).
Charge the Battery
1. Connect charging cable plug into 10-Bay Charger.
2. Insert AC Adapter into Power Outlet.
3. Charge Battery for 3 hours prior to use.
Battery Charging
Although the Batteries are partially charged at the factory, we recommend you fully charge them before
first use. Allow up to 3 hours for a full charge. Carefully insert the Battery into the charging slots.
Ensure that you follow the guidelines for Battery Safety described in Battery Safety Guidelines on
page 5. The multi-color LED will indicate the status of the charger as per the following table.
LED Status
Battery Charger Status
Red/Green/Off
During power up, indicates charger is operational
Solid Red
Charging
Solid Green
Battery fully charged
Off
No battery in charging slot
Charger Specifications
Charging Time
Approximately 1.5 Hours; Max Time: 3 Hours ± 30 Minutes
Operating Temperature
+32°F –+95°F (+0°C –+35°C)
Storage Temperature
-40°F –+122°F (-40°C –+50°C)
Input Voltage
100-240 VAC 50-60 Hz +/- 3Hz
Maximum Input Power
14.35W
Certification
CE, WEEE, UL (AC/DC Adapter only)

Part No: IDST Charger Manual v2.1 3
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by IDST is under license. Other trademarks and trade names are
those of their respective owners.
Patents
US Patent: D755,122, and D749,042
Operating and Cleaning Maintenance
To maintain the IDBHS Charger we suggest the following guidelines:
Do not expose the Charger to harsh chemicals or cleaning agents.
Do not charge the battery in damp or wet locations.
Do not store the battery or charger in damp or wet locations.
Do not use charger in the presence of explosive atmospheres (gaseous fumes, dust or flammable
materials).
Charge in a well ventilated area.
Do not block charger vents.
Keep vents clear to allow proper ventilation.
Do not allow smoking or open flames near a charging battery. Vented gases may explode.
If the Headset becomes dirty, wipe it off with a damp cloth. Do not use soap, cleaning fluids or
chemicals.
Keep dust, dirt and debris out of the Battery Charger Slots.
When handling the Headset Battery, keep the Battery Contacts free of dirt, grease, oil or other
substances that can affect the Battery from making proper contact with the Charger.

Part No: IDST Charger Manual v2.1 4
Troubleshooting
Operation
Problem
Possible Solution
Charging Battery
Battery does not seat properly in the
Charging Slot
Rotate Battery and re-insert into Charging
Slot.
Charging Battery
No LEDs Light on Charger when
Battery is inserted
Check Power Cable connection to Charger.
Charging Battery
No LEDs Light on Charger when
Battery is inserted
Battery may be faulty. Replace Battery.
Battery Safety Guidelines
The area in which the Batteries are charged should be clear of debris and combustible materials or
chemicals. Improper Battery use may result in a fire, explosion, or other hazard.
To charge the Headset Battery, the Battery and Charger temperatures must be between 0C and +50C
(+32F and +122F).
Do not use incompatible Batteries and/or Chargers. Use of an incompatible Battery or Charger may present
a risk of fire, explosion, leakage, or other hazard. If you have any questions about the compatibility of a
Battery or a Charger, contact your Distributor Customer Support.
Do not disassemble, open, crush, bend, deform, puncture, or shred.
Severe impact from dropping any Battery-Operated Device on a hard surface could cause the Battery to
overheat.
Do not short circuit a Battery or allow metallic or conductive objects to contact the Battery terminals.
Do not modify or remanufacture, attempt to insert foreign objects into the Battery, immerse or expose to
water or other liquids, or expose to fire, explosion, or other hazard.
Do not leave or store the Equipment in or near areas that might get very hot, such as in a parked vehicle,
near a radiator or other heat source.
Do not place Battery in a microwave oven, conventional oven, toaster oven, washer, dryer, dishwasher, or
other mechanical devices.
Battery usage by children should be supervised.
Please follow local regulations to promptly dispose of used re-chargeable Batteries.
Do not dispose of Batteries in fire.
Seek medical advice immediately if a Battery has been swallowed.
In the event of a Battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact is
made, wash the affected area with large amounts of water and seek medical advice.
If you suspect damage to your equipment or Battery, contact your Distributor Customer Support to arrange
for inspection.
Warranty and Customer Support
For the complete ID Services Taipei LTD hardware product warranty statement, call: [phone]
8415
If you have problem using your equipment, contact ID Services Taipei LTD Customer Support
at [phone]
For the latest version of this User Manual, call: [phone]

Part No: IDST Charger Manual v2.1 5
Safety and Regulatory Information
•Warnings for use of Wireless Devices. Please
observe all warning notices with regard to the
usage of wireless devices.
•Potentially Hazardous Atmospheres –
Vehicles Use. You are reminded of the need
to observe restrictions on the use of radio
devices in fuel depots, chemical plants etc.
and areas where the air contains chemicals or
particles (such as grain, dust, or metal
powders) and any other area where you
would normally be advised to turn off your
vehicle engine.
•Potentially Hazardous Atmospheres –Fixed
Installations. You are reminded of the need to
observe restrictions on the use of radio devices
in fuel depots, chemical plants etc. and areas
where the air contains chemicals or particles
(such as grain, dust, or metal powders).
•Contains small parts which can be a choking
hazard.
•Not suitable for children under age 3.
•This product contains magnets which can be
harmful to pacemakers, or similar medical
devices.
•To reduce the risk of fire or electrical shock, do
not expose the product to rain or moisture.
•As with any electronic products, use care not
to spill liquids into any part of the system.
Liquids can cause a failure and/or a fire hazard.
•Do not place any naked flame sources, such as
lighted candles, on or near the apparatus.
•Use caution when using your headset while
operating a vehicle or engaging in any activity
that requires your full attention. Check and
follow local laws regarding mobile phone and
headset use. Some jurisdictions impose
specific limitations, such as single earpiece
configuration, on the use of such products
while driving.
•Sounds that you rely on as reminders or
warnings may sound different when using a
headset. Be aware of how these sounds may
vary in character so you can recognize them as
needed.
•Do not leave a battery on prolonged charge
when not in use.
CAUTION:
Do not make modifications to the headset or
accessories. Unauthorized alterations may
compromise safety, regulatory compliance,
and product performance and warranty.
• Long-term exposure to loud music may cause
hearing damage. It is best to avoid extreme
volume when using a headset, especially for
extended periods.
• Use only with the supplied power supply
meeting local regulatory requirements (ex.
UL, CSA, VDE, CCC).
• Use caution when using a Headset while
operating a motor vehicle or anywhere the
inability to hear outside sounds may present a
danger to you or others.
• The Headset does not require scheduled
cleaning. Should cleaning be necessary,
simply wipe the outside surfaces with a soft
damp cloth.
Regulatory Information
All ID Services Taipei LTD devices are designed
to be compliant with rules and regulations in
the locations they are sold and will be labeled
as required. This regulatory information applies
to Model number IDBHS1-.
International
This device complies with internationally
recognized standards covering human exposure
to electromagnetic fields from radio devices.
Wireless Device Country Approvals
Regulatory markings, subject to certification,
are applied to the device signifying the radio
(s) is/are approved for use in the following
countries: United States, Canada, and Europe.
Note: Europe includes Austria, Belgium,
Bulgaria, Czech Republic, Cyprus, Denmark,
Estonia, Finland, France, Germany, Greece,
Hungary, Iceland, Ireland, Italy, Latvia,
Liechtenstein, Lithuania, Luxembourg, Malta,

Part No: IDST Charger Manual v2.1 6
Netherlands, Norway, Poland, Portugal,
Romania, Slovak Republic, Slovenia, Spain,
Sweden, Switzerland and the United Kingdom.
CE NOTICE TO USERS
ID Services Taipei LTD hereby declares that this
product is in compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC, 2011/65/EU and all other
applicable EU directive requirements.
FCC NOTICE TO USERS
This device complies with FCC and Industry
Canada RF radiation exposure limits set forth
for general population. It must not be
co-located or be operating in conjunction with
any other antenna or transmitter.
In the United States:
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, this is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, you are encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the Headset Charger to an outlet on
a different circuit than the one to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly
approved by ID Services Taipei LTD could void
the user’s authority to operate this equipment.
In USA and Canada:
This device complies with part 15 of the FCC
rules and Industry Canada license-exempt RSS
standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de
brouillage, et
2. l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en
compromettre le functionnement.
This class B digital apparatus complies with
CAN ICES-3 (B) / NMB-3 (B)
Waste Electrical and Electronic Equipment
This symbol on the product or on its packaging
indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of
your waste equipment by handing it over to a
designated collection point for the recycling of
waste electrical and electronic equipment. The
separate collection and recycling of your waste
equipment at the time of disposal will help to
conserve natural resources and ensure that it is
recycled in a manner that protects human
health and the environment. For more
information about where you can drop off your
waste equipment for recycling, please contact
your local city/town office or the distributer
where you purchased your equipment.