DIY Parts LSB02
8
Installation guide
Step 8
Use remote to control colors
and fans speed / Remote guide
Temperature
<30°C
30~40°C
40~50°C
50~60°C
60~70°C
>70°C
Color
Blue
Green
Yellow
Orange
Red
Blinking red and white
Fan output
5 V
7 V
9 V
10 V
11 V
12 V
(1) Power On / Off :
Turn on / off the computer
(2) Fan switch :
Control the fan's operation
(3) LED switch :
Turn on / off the LED lighting
(4) Temperature control mode :
When switching to temperature control mode, the fans will automatically adjust speed based on temperature
sensed by the thermal sensor cable. All LEDs will change color corresponding to changes in temperature
(5) Fan speed control :
Press this button first and then press speed up / down to adjust the fans speed.
When adjusting, the LEDs will light up in green and the current fan speed will be indicated by brightness.
The faster the fans spin, the brighter the LED will be
(6) Auto :
Adjust LEDs to the preset sequenced lighting mode
(7) Addressable mode 1 :
Adjust the LEDs graphics to make all LEDs lighten in the same pattern
(8) Addressable mode 2 :
Adjust the LEDs graphics individually. Press this button first and then select the port you want to adjust
(9) RGB mode :
Adjust the LEDs to the RGB color mode
(10~12) Memory 1 ~ 3 :
Long press 3 seconds to save the current state, short press to load the previous settings
(13) Mode Up :
Adjust the LEDs sequence
(14) Mode Down :
Adjust the LEDs sequence
(15) Brightness plus :
Increase LED brightness in RGB mode
(16) Brightness minus :
Decrease LED brightness in RGB mode
(17) Speed up :
Increase LEDs graphics speed or fans speed
(18) Speed down :
Decrease LEDs graphics speed or fans speed
(19~24) Addressable port 1 ~ 6 :
Assign LED port to adjust
(1) (2) (3) (4) (5) (6) (7) (8)
(9) (10) (11) (12) (13) (14) (15) (16)
(17) (18) (19) (20) (21) (22) (23) (24)
