Simmons SD1500 User manual

CAUTION!
While Simmons makes every effort to provide the highest quality products, metal shavings and/or burrs occasionally remain as a by-product
of the manufacturing process. To avoid injury, please use caution when adjusting clamps, or when working with pipe and screw ends.
Drum Rack Components
ASSEMBLY INSTRUCTIONS
The first name in electronic drums.
Before assembly, please check that all the items listed below are present.
Inside this package
rack assembly
1. Remove all preassembled tubing with clamps
from packaging.
2. Each T-Fitting and tube end-fitting is labeled with
a number. Lay the vertical and horizontal tubes
on the floor with the numbers matching.
L–Rods for Pads x5
Please note the numbers stamped on each
tube-end and tube-fitting
1
2
7
34
56
Left Left Center Right Center Right
Snare Drum
Pad Tube
Sound Module/Hi-Hat Tube
Tom Pad
Tube, Center
Tom Pad
Tube, Right

2
SD1500 ELECTRONIC DRUM KIT ASSEMBLY SHEET
8. If further adjustments of height and angle are required, loosen
the appropriate T-fittings with the 4 Drum Key Fasteners and
rotate, raise, or lower into desired positions. Retighten Drum
Key Fasteners making sure the gaps between the fittings are
close to even.
3. There is a Drum Key Fastener location on the end of each
fitting. Back this fastener out until the pointed end is no longer
protruding inside, but do not remove it. Do this for all the
fittings that have this feature on the vertical leg-fittings .
7. Loosen the Drum Key Fastener on fitting as above. Insert
Snare Drum into fitting and tighten. Loosen T-fitting with
the 4 Drum Key Fasteners and rotate into desired position.
Retighten Drum Key Fasteners making sure the gaps between
the fittings are close to even.
6. After you have the rack assembled, double check the
Drum Key Fastener and make sure they are all snug (do
not over tighten).
rack assembly CONTINUED
Match Numbers
9. Loosen L-rod wing knobs on tom clamps.
Insert black plastic end of L-rod into tom
clamps and tighten wing nuts.
4. Begin with T-fitting/tube end number and insert into the
corresponding left vertical leg. The surfaces of the fitting
should almost touch. Tighten the Drum Key Fastener until
snug (do not over tighten).
1
5. Continue assembling the rack working your way around to
T-fitting/tube end number (to the vertical right leg).
6
7
7
Completed Assembly