Simple LS-MJ-UC5E ERI Series User manual

The drawing appearing on this page is not a warranty,
and may be subject to change or modification without any prior notice. Rev. 1.0 1/2page
Installation
20001 LSSimple™ Cabling Solution
EnhancedRearIDCModularJack
1. Prepare the Easy Termination with ERI
Modular Jack.
1
Door Type Non door Type
2. Place the wires into the slots according
to the wire scheme.
2
3. Put the Keystone Jack onto the
Easy Tool in the right position and
then squeeze the tool then terminate
all wires and trim the excess wires at
the same time.
3 4
4. Remove the Keystone Jack
vertically away from the termination
tool.

The drawing appearing on this page is not a warranty,
and may be subject to change or modification without any prior notice.
Installation
20001 LSSimple™ Cabling Solution
EnhancedRearIDCModularJack
Rev. 1.0 2/2page
5. Place the cap and be
completion and
adjust cabe direction.
※ A. Inert the screwdriver into the slot between Cap & Jack Housing.
Use the screwdriver to pry the lid
B. Repeat the step A to unlock the other side.
C Completion.
A B C