Sister Bay MFIRE-RND Manual

Setup Instructions
Figure 1
1- Position the Fire Table roughly where it will be located. Choose a firm, level surface with a minimum of 24" from
any side wall and at least 72" clearance above in a well ventilated area.
We need access to the inside of the fire table. Carefully set the bags of Glass Gems (E) and box with the Glass
Cover (B) to the side. With the help of a partner, lift the Burner Pan (D) up and hold it to one side. The pan will
remain connected to the Control Panel (A) and Regulator, so don't pull too far. We need just enough room to
remove the box with the Wind Guard (C). Take the box out, set it to the side, and replace the Burner Pan.
Congratulations on your new Fire Table! It is fully assembled and has a few accessories than need
to be put together and placed. Please follow this set of guidelines to ensure your Fire Table will be
ready to use for years to come!
Components
TEMPERED FIRE
GLASS GEMS
E
TEMPERED GLASS BURNER
COVER
(SHIPPED ON TOP OF UNIT)
C
TEMPERED GLASS
WIND GUARD
(SHIPPED INSIDE UNIT)
B
BURNER PAN
D
CONTROL PANEL
A
(AS SHOWN)
BURNER PAN
D
WIND GUARD
(SHIPPED INSIDE)
C
Item No: MFIRE - RND
Fire Table Round
Setup and Care
Item No: MFIRE - RECT
Fire Table Rectangle

Figure 2
2- With the Wind Guard box removed, and the Burner Pan back in place, open the Gems bag (E) and slowly fill
the Burner Pan. Use your hand to spread them out evenly.
Figure 3
3- Now that the Gems are in place, the Wind Guard (C) needs to be assembled. Use the included Instruction
Manual to do so. This guard MUST be in place at all times during use. Failure to do so may result in damage to
the top. Your new Fire Table comes plumbed for Propane*. A standard 20 lb/4.5 gallon tank will fit into the tilt
out access location, simply connect the regulator to the tank. Your Fire Table is ready for use! Use the Burner
Pan Operation Manual for safe operation procedure and considerations.
* Note: When using natural gas, the
orifice needs to be changed.
Consult the Operation Manual for
the proper installation.
TEMPERED FIRE
GLASS GEMS
E
TEMPERED GLASS
WIND GUARD
C
Figure 4
4- Between uses, protect the polished stainless steel Burner Pan and keep debris out of the Gems by covering the
unit with the supplied Tempered Glass Burner Cover (B).
TEMPERED GLASS
BURNER COVER
B
* The Tempered Glass Burner Cover (B) is only meant to protect the polished stainless steel Burner Pan and keep
debris out and it MUST NOT be left on the unit while the flame is burning or the Fire Pan is hot. Failure to follow
may cause the Tempered Glass Cover ( B ) to break or shatter.
CARE AND MAINTENANCE
To clean your burner pan and surround, use a stainless steel cleaner with a soft rag.
To clean your product, use mild soap and water. For heavy soil build-ups use any non-abrasive household cleaners
or ask your Sales Representative about Sister Bay Furniture Cleaner.
Please contact our Customer Service Department for assembly assistance, questions or replacement parts at 1-866-947-7632
or email [email protected]. Our Customer Service Department is available Monday - Friday from 8:30 a.m. to 4:30 p.m. EST