Sit-Stand flytta RISER M User manual

ASSEMBLY GUIDE

TECHNICAL DATA
WHAT’S IN THE BOX
A x1 B x1
587mm
888mm 590mm
950mm
650mm
140-500mm
730mm
C x4 D x1
Max
2kg
3-15kg
IMPORTANT: Do not exceed the MAXIMUM bearing weight IMPORTANT: Surface must be larger than 950mm x 650mm.
STEP 1.
Take the product out of the box
and place it on the table.
Hook the keyboard tray onto the
installed knob, then tighten the knob.
Pull the handle upwards and adjust the
workstation to your desired working height.
STEP 2.
STEP 3.
IMPORTANT: Place the product on
a table large, strong surface, or it
may cause harm or damage.
IMPORTANT: Do no put your hands near
the supporting bars while adjusting the desk
height. The bars move and could cause
harm if obstructed.

STEP 4.
STEP 5.
Put your devices entirely on top of
your assembled workstation.
Use the self-adhesive nylon ties to attach
the cables to the underside of the desktop.
IMPORTANT: Do no allow any of your
equipment to stick out over the edges,
it may cause harm or damage.
IMPORTANT: Make sure there is enough
cable length for the full height of the desk
riser, otherwise it may cause damage.
IMPORTANT:
1. Before removing any equipment, adjust the desk riser to its highest setting to avoid harm or damage.
2. It is safer for two people to move the desk riser; moving it alone could cause damage or harm.
Use the velcro strap to gather your cables
together to avoid loose cables getting
caught in the mechanism.
Support contact
Telephone: [phone]
Email: info@ytta.com