SKD PS-1500 User manual

User's Manual
Sine Wave Line-Interactive

7.
INSTALLATION
CONTENTS

AC Input Voltage / Input frequency
Output Voltage / UPS's internal temperature
Battery Capacity
Load Level
UPS is working in battery mode
UPS is working in AC mode
Fan Failure
UPS will alrarm in DC mode
Charging current mode
Turn on / Turn off / Silence function
Choosing the charging current
“OK” button for confirming the charging current
1 1
1 0
1 2
BATTERY
CONNECTOR
Select
POWER
2
1
10
11 12
PS-1500 PS-2000/PS-3000
BATTERY
CONNECTOR
DATA LINE
PROTECTION
INPUT POWER
CABLE
DATA LINE PROTECTION
OUTPUT
OUTPUT
BYPASS
220V~,50Hz
AC INPUT
250V~,10A
Dat a Line Pro tection
Breaker
Ext ernal batter y
24VD C
USB Po rt
USB Port
INPUT 220V~
BREAKER
13A,250V~
48V
BATTERY
OUTPUT:220V ,50Hz~
BYPASS
FAX/ MODEM
USB P ort
USB Port

POWER
POWER
POWER
POWER
30

PS-1500
Rated capacity
Real power
DC voltage
1500VA 2000VA 3000VA
12V/7AH×4
Battery type
1050W 1400W 2100W
12V/9AH×2
1.5A/3A
405×145×220 405×145×220
V
PS-2000 PS-3000
12V/9AH×4
<2-4ms

Cautions:
Please cut off the load equipment before connecting to UPS, then turn on
the equipment from sequence with big load to small load.
Connect UPS to the special socket with current protection.
All the power sockets should connect with earth wire.
UPS output sockets may with current no matter it is connecting to the utility
power socket or not, UPS off is not assure the component without current.
In order to cut off the UPS output, please cancel the utility power supply
then turn off the UPS.
It is suggested to charge batteries 8 hours for standard type UPS. UPS is
automatic charging whenever power is connected. It can be used at once
even without charging, but the back up time will be less then the standard
value.
When connecting inductive load equipments to UPS such as motor ,
monitor, laser printer etc., because their start up power are too big, the
estimated capacity of load should be as same as start up power. Start up
power is two to five times as regular capacity which based on the load
characteristic.(More details please read the chapter 2 “DESCRIPTION OF
APPEARANCE”)
7 INSTALLATION.
Put the UPS in ventilated area, kept it away from water, combustible gas and
corrosive.
Keep UPS upright and all the vent holes on panels opened.
Keep temperature around UPS in degree of 0℃ to 40℃.
If transfer the UPS from hot space to cold space, condensation of water trop
will happen, please ensure the inside and outside of UPS are totally dry ,
otherwise it will cause short circuit and damage the UPS.
Please put the UPS near to the utility power input sockets, in order to cut off
the utility power in emergency situation.
7.1
7.2
7.3
7.4
7.5