QUICKSTER®4-IN-1 FB TRAINER ASSEMBLY
STEP 1 BASE FRAME & TENSION-TITE™ ARM POLE
1. Lay out one Arm Pole (C) and link together to form a straight
pole. Repeat with the second Tension-Tite Arm Pole.
NOTE: Base Frame and Tension-Tite arm poles come pre-
attached by elastic cords.
2. Lay out Base Frame (B) and link the frame together. Make
sure to secure the poles with the push buttons.
3. Slide a Tension-Tite Arm Pole into each side of the Base
Frame.
NOTE: Ensure arm poles are fully inserted. Failure to do
so may result in damage to the Quickster.
STEP 2 CONNECT THE NET TO THE FRAME
1. Unfold the Net (A) and slide the pin at the top of one corner
of the net into the top of the Tension-Tite Arm Pole. Make
sure that the Quickster logo on the ball collection skirt is
facing away from the frame. Repeat on the other side.
2. Attach bottom Net loop attachments to the plastic post
hooks on each side of the Base Frame (B).
3. Attach the back of net to Arm Poles (C) by using the Velcro
straps.
NOTE: Check the frame to make sure it is securely and
fully assembled with the net before securing to the
ground.
4. Attach the ball collection skirt to the toggle hook
attachments.
NOTE: The ball collection flap should be detached and
folded down during punting practice.
Webbing attachment
2
1
3
1
2
3
VELCRO
STEP 3 SECURE THE QUICKSTER
1. Place the Quickster in the desired location and ensure it is on
level ground. Secure frame with included Ground Stakes (E).
Ground Stakes can be secured with hand, foot or mallet.
NOTE: Care should be taken when pressing in the ground
stakes. Pole can be bent if driven too far into the ground or
hard surface.
CAUTION: Make sure the Quickster is secured into the
ground before play. During play, make sure the Ground
Stakes are secure as a loose Ground Stake may cause injury.
B
ONLY SECURE STAKES WHERE INDICATED ABOVE.
E
B
E
STEP 4 ATTACH HIGH-VIZ TARGET (optional)
1. Unfold the Target (D) and find the top straps (with adjustment
buckles).
2. Attach hook of the top strap through the fabric loop at the top left
corner of the net, repeat on the other side.
3. Take one of the bottom straps of the target and hook through
fabric loop on the bottom corner of the net, repeat on the other
side.
NOTE: Two of the webbing straps are shorter to adjust
placement within the frame. For a lower target (ideal for
snapping), attach the short straps at the bottom (1). For a
higher target (ideal for passing), attach the short straps to the
top (2).
Bottom Attachment
fabric loop
Top Attachment
fabric loop
snapping passing
1 2
STORING YOUR QUICKSTER
1. Remove the Ground Stakes and place the Ground Stakes into the carry bag.
2. Hold one pin in one hand and one Tension-Tite Arm Pole in the other while pulling the pin out. Repeat on the other
side. Remove the net loop attachments from each side of the frame. If needed, air dry the net before you fold and
place it into the carry bag.
3. Pull the Tension-Tite Arm Poles out of each side of the base frame, unlink and fold them down to store.
4. Unlock the push button on the Base Frame to unlink the frame. Fold and store in
carry bag.
NOTE: Store Tension-Tite Arm Pole in the carry bag with the round tops facing away from each other.
