SkyBound SWING NET Setup guide

swing net
ASSEMBLY AND INSTALLATION MANUAL
www.SkyBoundUSA.com
www.TrampolinePartsCenter.com
[email protected]
A PERSONAL MESSAGE FROM OUR FOUNDER
888-891-4689
Monday through Friday
8:00 am to 5:00 pm PST
or visit www.SkyBoundUSA.com
or www.TrampolinePartsCenter.com
-Kiki (Founder) & Team SkyBound
For customer service, please contact:
“Nurturing the inner-child in all of us by
uniting communities worldwide and
promoting an active lifestyle.”
When I shop, I am not just buying a product or
service. I purchase why that brand focuses on
what they do, what their corporate philosophy is,
the quality of their products, and whether or not
my personal core values align with that brand’s
vision. When I don’t feel great about a company’s
brand, products, or how I’m being treated as a
customer, then I know they are not delivering on
what matters most: exceeding the customer
expectation by delivering happiness with their
products, quality, and service.
This primary focus is what drives our culture at
Team Skybound. For supporting our vision, we
would like to personally thank you for trusting us
to deliver happiness to you and your family!
2022 BX International Inc – ALL RIGHTS RESERVED

IMPORTANT INFORMATION
WARNING
!
ASSEMBLY INSTRUCTIONS
STEP 1
Lay the swing (1) on the floor
and open the tabs with the
Velcro straps.
STEP 2
Slide swing tubes (2) into the
pockets of swing (1) as shown
below. Connect the four tubes
together.
This object is subject to wear and tear. No warranties whether expressed or implied
are provided.
Injury will likely occur with the use of a trampoline or any associated product.
Use with supervision.Use at your own risk.
Only Use in a well-lit, well secured down area.
NO.
1
2
3
4
4
2
1
1
Part Name
Mat
Tubes
Rope
Tent
Pictures Quantity
INSTALLATION STEPS OF SWING NET FRAME
12

Make sure that a thicker tube
end with a hole follows a pipe
end with a spring button.
NOTE: Do not connect the
tubes yet.
STEP 5
Slide the plastic suspension of the
rope (3) from above through the
opening of the tab with the Velcro
straps. Then use side “II”(see mark-
ing) to attach the susension to the
thicker tube.
STEP 6
Now connect the tubes to each other, while pressing down the spring
pressure button on the thinner end of the tube. The inter-locking is
achieved through the latching and clicking of the push button.
Now, close the tab with the Velcro straps.
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
STEP 3
STEP 4
INSTALLATION STEPS OF SWING NET FRAMEINSTALLATION STEPS OF SWING NET FRAME
Place the two ropes (3) with the suspensions made of plastic in the correct
sequence next to the swing (1). Please make sure that the ropes are not
twisted.
3 4

On the swing that has been installed,
install 4.
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
STEP 7
INSTALLATION STEPS OF SWING NET FRAME
INSTALLATION STEPS OF SWING SET FRAME
4
[phone]
SkyBound Customer Service
[email protected]
SkyBoundUSA.com
Installation completion drawing
5 6
SkyBound, a BX International Inc Company.
SkyBound is a registered trademark of BX International Inc.
in the U.S. and other countries. All logos, names,
characters, likenesses, images, slogans and
packaging appearance are the property of SkyBound.