Skyvue NXG-55 User manual

Table Stand
Installation
NXG-55 / NXG-65 / NXG-70 / NXG-80
*This Installation requires a minimum of two people.

2All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
Lay television down, viewing side down on blanket.
Lay blanket down on at sturdy
surface. Run hand over sur-
face to make sure there are no
sharp object or protrusions,
when the television is laying
down.
Note: TV examples may vary slightly. All arms and mounts have
been shippd in the approprate size to match the television of your order
and will assemble using the same with the following instructions.
The following instructions will work for the NXG55, NXG65, NXG70,
and NXG80 inch televisions.

3
InstallatIon Manual
nXG 55 / nXG 65 / nXG 70 / nXG 80 |
Gather the 4clamping nuts with springs. These will be in a separate
bag shipped with the User Manual Packet.
1: Remove the hex head screws and
washers. Set the screws and washers in a
secure location.
2: Insert spring nuts as shown in
picture (2 per power strut). Spring should
be touching both sides of the power strut
as shown.
3: Align holes of the mounting arms
with the holes of the clamp nut springs.
The arms should be level with each
other. Insert the hex head screws and
washers from the rst step and secure
tightly as shown in the example to the
right and below.

4All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
Align the holes of the arms with the spring nuts the back of the television.
STAND SWIVEL
GATHER THE FOLLOWING:
STAND ARMS

5
InstallatIon Manual
nXG 55 / nXG 65 / nXG 70 / nXG 80 |
Reinsert the Bolts with the at washers and tighten securely into
all 4 clamp nuts.
Align the lower holes of the arms with the holes the swivle stand.

6All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
Place mounting plate on your tabletop. Use 4 holes indicated in the red
circles to drill holes in your table top surface. Insert the fasteners that you
have purchased and tighten securely.
Reinsert the bolts with the at washers and tighten securely.

7
InstallatIon Manual
nXG 55 / nXG 65 / nXG 70 / nXG 80 |
The main bolt for your SkyVue table stand is shipped with a protective
coating on it. At this time please remove it.
Have a friend assist you with placing the television on the stand and apply
washers and nut as follows.

8All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
Place the provided plastic spacer
on the bolt shaft.
Followed by the provided
Stainless Steel Washer
Place the provided
Stainless Steel Lock Washer
Then completed with the
provided Stainless Steel Nut.
Be sure not to over tighten.

9
InstallatIon Manual
nXG 55 / nXG 65 / nXG 70 / nXG 80 |
On the back of your table stand - Insert and secure the torque screw with
plastic spacer.

10 All Rights Reserved. 2017 SkyVue®
Installation Manual - Table Swivel Stand
Congratulations you have successfully installed your table
stand. If you have any questions call our tech support team
(877)-475-9883 option 2