SkyZone Micro Park Flyer Micro Stick 4383SZ User manual

Wingspan:15” (392mm)
Wing Area:84.3“ (5.44dm2)
Length:16” (402mm)
Weight:1.1 oz. (30g)
JE7097

INTRODUCTION 1
ITEMS INCLUDED 2
OTHER ITEMS REQUIRED 2
COMET COMPONENT 2
FUNCTION OF TRANSMITTER 3
CHARGING BATTERY 4
TRANSMITTER CONFIGURATION 5
MAIN WING ASSEMBLY & BALANCE 6
PRE-FLY CHECK 7
IN-FLY 8
POST-FLY MAINTENANCE 10
PARTS DRAWINGS 11
1
INTRODUCTION
Thanks for your purchase of Sky Zone Micro Park Flyer series. Equipped with all-in-one RX Board & Control
Linkage, powerful Coreless Motor with efficient Propeller and compact size with relative ease of setup, the
ready-to-fly Micro Park Flyer series has become the most popular class of RC aircraft for modeller to get
involved in the hobby of RC flight in an inexpensive and convenient way.
Before beginning your first flight please read all instructions in this manual thoroughly to obtain a full
understanding of the sequence of steps and a general awareness of the recommended configuration
procedures. Check the entire contents of your plane in the manual to ensure that no parts are missing or
damaged. If parts are missed or damaged, please contact with the authorized distributors for customer service.
As you follow our instruction adequately, we are confident that you would enjoy flying SkyZone
Micro Park Flyer that provides lots of rewarding flights.
TABLE OF CONTENTS

3

2-1/8” (54mm)
MAIN WING ASSEMBLY
BALANCE
Locate the front/rear wing strut then insert into the retainer as illustrated.
Make sure the wing is fixed properly.
Check the C.G. for proper balance. Remove the retainer if necessary.

10
POST-FLY MAINTENANCE
1. Disconnect LIPO battery and then turn the
transmitter power OFF.
3. Do not use any solvents to clean the plane surface,
or it will damage the foam and plastic. Use a dry
cloth to clean any dirt from outside of aircraft.
2. Check the airplane completely. Do the mechanical
trim of all control surfaces to make the trim neutral
in position on transmitter.
Landing
Make the plane against wind and
adjust rudder control stick to avoid any
left/right lean during flight.
Once approaching the ground, please
adjust elevator stick to keep the plane
flying straight for smooth landing.
Keep the plane
flying horizontal.
Move throttle control stick downward gently
to reduce flying speed and altitude.

PARTS DRAWINGS
AS9288SZ Wing AS9289SZ Tail set
AS9290SZ Propeller
AS9291SZ Battery ( 150mAh ) AS9292SZ Nose landing gear
11