Fisher-Price Imaginext CHG26 User manual

1
IMAGINEXT COM
IMAG
IN
N
EXT.COM
IMAGINEXT.COM
CHG26
alkaline
Requires four AA (LR6)
batteries (not included)
for operation.
1,5V x 4
AA (LR6)
Wipe this toy with a
clean, damp cloth.
Do not immerse in water.
Keep this instruction sheet
for future reference, as
it contains important
information.
Adult assembly is required.
Tool required for bat ter y
installation: Phillips screwdriver
(not included).

2
Assembled Parts
Body
2 Arms
2 Legs
Tail
Ladder
Hint: This may be
factory assembled.
Battery Installation
• For longer life, use alkaline batteries.
• Locate the battery door on the bottom of
the toy.
• Loosen the screw in the battery compartment
door and remove the door.
• Insert four AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screw. Do not over-tighten.
• If this toy begins to operate erratically, you
may need to reset the electronics. Slide the
power/volume switch off and back on.
• When sounds/lights/motion become faint
or stop, it’s time for an adult to change
the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
©2015 Mattel. All Rights Reserved.
PRINTED IN CHINA
CHG26-0970
1100356582-DOM

3
Assembly
Hint: The ladder may be factory assembled.
• At an angle, fit a peg on the ladder into a
slot in the back of the body. Push to “snap”
the other side of the ladder in place.
• The ladder is designed to break away from
the body. If it comes off, simply follow the
steps above to assemble it!
4
• First, “snap” the bottom of the leg onto the
body A. Then, “snap” the top of the leg
onto the body B.
Hint: The legs are designed to fit onto the
body one way. If the leg does not seem to fit,
try the other leg.
• Repeat this procedure to assemble the
remaining leg to the body.
1
• “Snap” each arm onto the upper body.
Hint: Each arm is designed to fit onto the
body one way. If an arm does not seem to fit,
try the other arm.
2
2
• “Snap” the tail onto body.
Hint: The tail is designed to fit onto the body
one way. If it does not seem to fit, turn it
around and try again.
3
3
Ladder
Arm
Leg Tail
A
B

4 5
Slide the power switch to
ON or OFF.
POWER SWITCH
POWER SWITCH
Walk, Stomp, Stand and Roar!
Hints:
- Only sounds and lights will activate if T-Rex is in the upright position.
- T-Rex’s mouth will always be open when he is in the upright position.
- Push T-Rex’s back to lower him down.
Turn the power pad to the left
to launch arrows! Turn to the
right to open and close T-Rex’s
mouth, and hear him roar!
Turn the power pad to
raise T-Rex up, and play
sounds and lights!
Turn the power pad
for walking motion,
sounds and lights!
Push T-Rex to hear
more fun sound effects!
Do not aim at eyes or face. Only use
projectiles supplied with this toy.
Do not fire at point blank range.
WARNING
Load the a boulder into each
cannon. Press the trigger to
launch with sounds and lights!
You can also load boulders
into T-Rex’s spine and push
the lever to launch them!
Press the button to shoot claws!
Release the trap door to
send figures to the jail!
Easily store the glider on
the cannon platform.
Fire arrows from
T-Rex’s mouth!

6
C
ONSUMER ASSISTANC
E
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.However, there is no
guarantee that interference will not occur
in a particular installation.If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority
to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device may
not cause harmful interference, and (2) this
device must accept any interference received,
including interference that may
cause undesired operation.
Battery Safety Information
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.