SloanLED 60W3 User manual

60W3 12 VDC Power Supply
Installation Guide for PN 701507-60W3 – NEC Class 2 Output
PAGE 1 OF 2
1. Tools required: Wire strippers,
drill, and screwdriver.
2. Supplies required: Junction box,
#8 or #10 pan head screws,
UL Listed PLTC cable, UL Listed
electrical wire connectors
(e.g., wirenuts), silicone.
3. Power Supply: Identify primary
wires, secondary wires, and
location of mounting tabs.
4. Mount Power Supplies:
Use mounting tab in corner to
secure power supply.
NOTE: Power supply operating temperature is -40º C to 60º C. To ensure adequate
ventilation, mounting power supplies without a secondary enclosure is recommended.
Space power supplies by standard knockout locations 3/4 in (19 mm) minimum. If two or
more power supplies are used, spacing must be at least 1 in (25 mm) end-to-end, and
4 in (102 mm) on each side. Power supply spacing to thermoplastic, wood, ber, or
other combustible enclosure materials must be 1 in (25 mm). Ensure power supplies are
not overloaded by verifying output current is less than 5 DC Amps. Use of photo-cells or
timing device is recommended to ensure power supplies are o󰀨 during day light hours,
when sign illumination is not needed. Higher daytime temperatures and unnecessary
operation may shorten power supply lifetime.
12 VDC Output
(Red & Black)
Mounting Tabs
Primary Wires
5. Congure Power Supplies: Secure power supplies to junction box using
1/2 in (13 mm) locknuts. Power supplies may be joined together in a wide array
of congurations. For wet locations use a junction box that is UL Listed for wet
locations. For dry locations, use any UL Listed junction box.

60W3 12 VDC Power Supply
Installation Guide for PN 701507-60W3 – NEC Class 2 Output
PAGE 2 OF 2
Customer service and technical support
888.747.4LED (888.747.4533)
SloanLED.com • [email protected]
Europe: Customer service and technical support
[phone]
SloanLED.com • [email protected]
P/N 402390 Rev A 2019-04-22
Some or all of the products shown are covered by U.S. and foreign patents pending and covered by one of more of the following U.S. patents issued: 6776504, 6969179, 7192157, 6932495, 7241031
SloanLED products carry a limited warranty.
For complete details refer to the warranty policy found at SloanLED.com
6. Connect Primary:
CAUTION: Have a licensed
electrician connect primary.
7. Make secondary connections: Secondary
class 2 cables do not require conduit per
NEC 2008 Articles 725.121 through 725.130.
Seal all wall penetrations with silicone to
avoid water damage.
TROUBLESHOOTING
If sign is not functioning properly, check the following:
• Primary voltage is between 100-277 VAC
• Secondary voltage is 12 VDC
• Output current is 5 Amps or less
• Power supply is not overloaded (see Power Supply Capacity
Chart in product installation guide or SloanLED.com)
• There are no shorts in secondary wiring
• All secondary connections are RED-TO-RED and BLACK-TO-BLACK
UL File number: E336107 UL8750
E215393 UL879
Wall penetration
(seal with silicone)
Power supply
UL Listed
junction box
Primary
power
Sign or
channel letter
Connect secondary
output. Ensure
all secondary
connections are
RED-TO-RED and
BLACK-TO-BLACK