SloanLED 701507-60W2 User manual
60W2 12 VDC Power Supply
Installation Guide for PN 701507-60W2 – NEC Class 2 Output
PAGE 1 OF 2
1. Tools required: Wire strippers,
drill, and screwdriver.
2. Supplies required: Conduit and
electrical enclosure for power
supply (if not placed in a sign made
from enclosure rated material),
#8 or #10 pan head screws,
UL Listed PLTC cable, UL Listed
electrical wire connectors
(e.g., wirenuts), silicone.
3. Power Supply: Identify primary
wires, secondary wires, and
location of mounting tabs.
4. Mount Power Supplies:
Use mounting tab in corner to
secure power supply.
NOTE: Power supply operating temperature is -40º C to 60º C. To ensure adequate
ventilation, mounting power supplies without a secondary enclosure is recommended.
Space power supplies by standard knockout locations 3/4 in (19 mm) minimum.
If secondary enclosure is used (transformer can), power supply spacing to other
heat producing components must have 4 in (102 mm) of space on each side and
2 in (51 mm) minimum to top of enclosure. Ensure power supplies are not overloaded
by verifying output current is less than 5 DC Amps. The use of photo-cells or timing
device is recommended to make sure power supplies are o during day light hours,
when sign illumination is not needed. Higher daytime temperatures and unnecessary
operation may shorten power supply lifetime.
12 VDC Output
(Red & Black)
Mounting Tabs
Primary Wires
5. Congure Power Supplies: Secure power supplies to junction box using
1/2 in (13 mm)locknuts. Power supplies may be joined together in a wide array
of congurations. For wet locations use a junction box that is UL Listed for wet
locations. For dry locations, use any UL Listed junction box.
60W2 12 VDC Power Supply
Installation Guide for PN 701507-60W2 – NEC Class 2 Output
PAGE 2 OF 2
Customer service and technical support
888.747.4LED (888.747.4533)
Europe: Customer service and technical support
+31 88 12 44 900
P/N 401984 Rev A 2016-10-12
Some or all of the products shown are covered by U.S. and foreign patents pending and covered by one of more of the following U.S. patents issued: 6776504, 6969179, 7192157, 6932495, 7241031
SloanLED products carry a limited warranty.
For complete details refer to the warranty policy found at SloanLED.com
6. Connect Primary:
CAUTION: Have a licensed
electrician connect primary.
7. Make secondary connections: Secondary
class 2 cables do not require conduit per
NEC 2008 Articles 725.121 through 725.130.
Seal all wall penetrations with silicone to
avoid water damage.
TROUBLESHOOTING
If sign is not functioning properly, check the following:
• Primary voltage is between 100-277 VAC
• Secondary voltage is 12 VDC
• Output current is 5 Amps or less
• Power supply is not overloaded (see power supply capacity chart
in product installation guide or SloanLED.com)
• There are no shorts in secondary wiring
• All secondary connections are RED-TO-RED and BLACK-TO-BLACK
UL File number: E336107 UL8750
E215393 UL879
Power supply
Primary
power
UL listed
junction box
Wall penetration
(seal with silicone)
Sign or
channel letter
Connect secondary
output. Ensure all
secondary connections
are RED-TO-RED (+)
and BLACK-TO-
BLACK (-)
Other SloanLED Power Supply manuals
