SLX P20 User manual

Fabric Indoor Antenna P20
27805R
User Guide
Support: www.slxtechnology.com/support
Introduction
Congratulations on the purchase of your new
SLX P20 Fabric Indoor Antenna.
The P20 antenna is designed to receive
VHF and UHF terrestrial TV signals indoors
without requiring a power source. It is ideal for
receiving all available VHF and UHF channels
in strong signal areas (typically within 0-10
miles of a transmitter).
• Optimized for digital reception - Supports
Freeview on HD and 4K screens
• Unique attractive fabric nish
• 1.5m High quality coaxial cable - fully
screened to minimise interference
• Designed to provide maximum
performance in urban areas
• Compatible with signal boosters when
signal is weak
General Safety Precautions
• To clean rst disconnect from your TV and
use a lightly dampened soft cloth. Do not
use chemical solvents or strong detergents
• Do not attempt to open the unit, there are
no user serviceable parts
• Do not expose to direct sunlight, very high or
low temperatures, moisture, liquids, strong
magnetic elds high frequencies and dusty
environments
• If anything goes wrong, contact our
technical support team
Installation
Before installation make sure your TV is
switched off. Select a location on a at
surface preferably high up and in line of sight
of a window. Plug the coax plug on the end
of the antenna cable into the “Antenna In”
socket on your TV. Make sure you run the
cable so that it will not be in a position where
people could trip over it.
Switch on your TV and search for channels.
Rotate and adjust the position of the aerial
to nd the best alignment and location for
optimum reception.
ANT IN
or PVR
Rotate to nd best
alignment
Flat
mounted
Wall mounted
mount on a wall
facing a window or
nearest transmitter
Stand
mounted
TV
Rotate to nd best
alignment

Troubleshooting
If you experience reception problems after
installing your SLx antenna, please see below:
No picture or sound
Check the antenna coax plug is properly
plugged in to the correct socket on your TV.
Picture or sound breaking up
- Adjust the location of the antenna, place
closer to a window.
- Place the aerial higher up.
- If the signal isn’t strong enough (you are
too far away from the nearest transmitter)
try tting a signal booster.
For specic help with digital TV reception
problems in the U.K., visit:
www.digitaluk.co.uk or www.bbc.co.uk/
reception/television/freeview/reception_
problems
In the U.S.A., visit:
www.fcc.gov/media/engineering/dtvmaps
or https://antennaweb.org/Address
Check online for similar information in other
countries.
Support: www.slxtechnology.com/support
2
Waste electrical and electronic
products should not be disposed of
with household waste. Please recycle
where facilities exist. Check with your
Local Authority for recycling advice.
© Philex Electronic Ltd 2018. v1.1 MK42 0NX
Technical Support
If you experience problems setting up your
aerial, please visit our technical website at
www.slxtechnology.com/support to send us
a message or chat live during ofce hours.
Antenna Frequency Dimensions Max Gain Cable Length
27805R VHF & UHF 180 x 185 x 40mm 3dBi 1.5m
Specications
Philex reserve the right to modify their designs or specications, In the light of future developments, without prior
notice. Performance gures quoted are typical and subject to normal manufacturing and service tolerances.
Wall mounting
Mount the P20 on a wall facing a window or
the nearest transmitter. Before mounting try
out as many positions as possible within 1.5m
range of the ANTENNA IN socket on the TV/
PVR. When you have located the best spot for
reception, drill two holes with centres 70mm
apart to t wall plugs and screws of a suitable
size to t in the keyhole slots. (Screws and wall
plugs not supplied - Drilling template below).
Wall mount drilling template
70mm
Keyhole Slots
for wall mounting