smania RC FIGHTER JET AIR JET User manual

INSTRUCTIONS
RC FIGHTER JET AIR JET
PACKAGE CONTENT
•Jet
•Remote controller
•LED lights
•Landing gear
•Replacement propellers
•Charging cable
TECHNICAL SPECIFICATIONS
•Material: EPP foam, ABS
•Airplane size: 8 ×24,8 ×34,2 cm
•Battery: 3,7 V, 200 mAh rechargeable
•Remote battery: 2 ×1,5 V AA (not included)
COMPONENTS
1. Front landing gear slot
2. Battery compartment
3. ON/OFF switch
4. LED light power connectors
5. Propellers
6. Rear landing gear slot
BEFORE THE FIRST FLIGHT
•Remove the battery from its compartment and
charge it with the included charging cable.
Connect the battery to the cable and connect the
cable to your computer or phone charger. The
red light is on while the battery is charging. When
the battery is fully charged, the light turns off.
•Insert the fully charged battery back into the
battery compartment and connect it to the plane
(using the connector inside the battery
compartment). Close the compartment cover.
•If you want to use the plane’s landing gear, put it
into the corresponding landing gear slots. TIP: the
landing gear with only one wheel goes in the
front.
•Remove the battery compartment cover on the
controller and insert two AA batteries (not
included in the package). Mind the polarity. Once
the batteries are inserted, close the battery
compartment cover.
•To install the LED lights, remove the protective
strips on the lights and stick them to the plane
anywhere you want. Connect the power strips to
the LED light power connectors on the plane.
Refer to the components diagram for more info.
FLYING THE PLANE
•Turn ON the controller by pressing the round
button in the middle. A red light will turn on
indicating that the controller is turned ON. This
button is also used to turn OFF the controller.
•Then, turn ON the airplane by flipping the
ON/OFF switch on the bottom of the plane to the
ON position. A red light will come on when the
plane is ON and connected to the controller.
•The plane can start from the ground (if it has the
landing gear installed), or you can throw it.

•To start from the ground, make sure that the
landing gear is installed, then place it onto a flat
and smooth surface outside.
•With both the plane and the controller turned
ON, slowly press the accelerator forward (left
lever). The plane will start moving, use the right
lever for steering (both on land and in the air). It
might take a few meters to take off, so make sure
there’s enough space for the plane to maneuver
on the ground.
•You can also throw the plane like a paper plane
to make it fly. Make sure that the propellers are
spinning at full throttle before throwing to
maximize lift and achieve easy flight. When
throwing the plane, be wary of the spinning
propellers and don’t put your fingers near them.
Also be aware of your surroundings.
TROUBLESHOOTING
•If the propellers get damaged, please replace
them with the spare propellers included in the
package. Check the markings on the propellers
to see which one goes on which side. The A1
propeller should be on the left side of the plane
and the B1 should be on the right side.
•If the body gets damaged, use tape to repair it.
Do not fly the plane if it’s damaged and you
have not repaired it beforehand.
WARNINGS
•Do not bend the wings and the landing gear.
•Only fly outdoors and make sure there are no
power lines or obstructions nearby.
•Do not fly the plane into people, traffic, or
animals.
•Children should only operate the plane under
adult supervision.
•Remove the batteries from the plane and the
remote control and turn both OFF when not in
use.
•Only use the included charging cable to charge
the battery.
WARRANTY
The warranty is valid for 24 months. You can claim it
from DFVU d.o.o. družba za posredništvo, Liparjeva
6a, 1234 Mengeš, Slovenia, for a replacement
product or a refund. Send us your order number and
purchase date in the email, which is available by
clicking on our logo in the bottom right corner. The
product has a lifetime of 24 months from the date of
collection.
WEEE disposal and recycling
symbol. The WEEE symbol is
attached to the product in
compliance with the EU directive
2012/19/EU on Waste Electrical
and Electronic Equipment (WEEE).
It is intended to deter the improper
disposal of this product and to
promote reuse and recycling.