Smart Lab RoboXplorer Multi Terrain Robotic Toy... User manual

build it!
Before you begin testing the limits of your Robo-6,
you’ll have to put it together. Here’s how.
equipment needed for robo-6 tests
• An assembled Robo-6
• Sidewalk chalk
• Books (to make stairs)
• Tape measure
• Toy cars
• A stopwatch, or a watch that
counts seconds
• String: a 10  piece and a 2  piece
parts
Shell
top
Shell
bottom
with hitch
S-legS with
traion
padS
gearbox
axle
coverS
axle
SupportS
hubpS
axl
4-Short
2-long
3
Put axle
supports
onto axles.
Axle supports
go on either
direction and
fit on both
size axles.
Insert gearbox wire plug into shell bottom.
Tip the gearbox into
the shell bottom so the
lights line up with the
holes in the shell bottom.
Snap the gearbox
into place.
2
4
No
Secure axles, as pictured—short
axles in the front and back;
long axles in the middle.
1
yes

Snap all six axle covers
into place, as pictured.
Place shell
top on top
and snap
together.
It only fits one way, with the
see-through plastic rectangle
over the gearbox.
To ensure proper safety and operation,
the battery replacement must always
be done by an adult.
Never let a child use this product
unless the battery door is secure.
Keep all batteries away from small
children, and immediately dispose
of any batteries safely.
Batteries are small objects and
could be ingested.
Nonrechargeable batteries are
not to be recharged.
Rechargeable batteries are not
recommended for use with this toy.
The supply terminals are not to be
short-circuited.
Rechargeable batteries are to be
removed from the toy before being
charged.
Rechargeable batteries are only to be
charged under adult supervision.
Different types of batteries or new and
used batteries are not to be mixed.
Only batteries of the same or equivalent
types as recommended are to be used.
Do not mix alkaline, standard
(carbon-zinc), or rechargeable
(nickel-cadmium) batteries.
Batteries are to be inserted with
the correct polarity.
Exhausted batteries are to be
removed from the toy.
Attach the s-legs as pictured—first the
front and back, then the middle. Each
s-leg should read like an “S.”
Attach hubcaps—twist to the right.
Remove the battery compartment
cover. Install three 1.5 volt AAA
batteries, as pictured.
Replace cover.
Make sure all s-legs are
attached as described in
the assembly instructions.
Like the cockroach who
always has three legs on
the ground at one time,
Robo-6 works best when
its legs are positioned in
a triangular pattern.
Turn three s-legs, as pictured,
so they form a
triangular pattern.
Attach the s-legs as pictured—
first the front and back, then the
middle. Each s-leg should look
like a backwards “S.”
Attach hubcaps—twist to the left.
7
10
9
troubleshooting
The s-legs may get misaligned when the
Robo-6 is walking on sand and climbing
over rocks. You can adjust the s-legs by
turning them back into place (you’ll hear
them click!) rather than taking them off
and reattaching them.
1
2
If Robo-6 veers off course, just
nudge him back into place.
3
8
5 6
Note:
The on-off
switch is on the
bottom of
Robo-6.
battery cautions!