1 Box contents
Make sure you receive all items of your shipment:
• One SCP-P4040-4G-ENP2 board
• One printed copy of Quick Start Guide (this document)
• One printed copy of Safety Notes Summary
When installing or servicing the system or accessories,
strictly observe the safety precautions in the Safety Notes
Summary. Ignoring these instructions can void the system
warranty and cause personal injury or property damage.
2 ESD
Electrostatic discharge and incorrect installation or
removal of the card can damage circuit or shorten its life.
Use a properly grounded ESD wrist strap or work in an
ESD-safe environment.
Connect to the ESD connector at the front or the rear of
the system.
3 Site preparation
Operating temperatures refer to the temperature of the air circulating
around the blade and not to the actual component temperature.
For more information about connecting cables and power cords,
refer to the SCP-P4040-4G-ENP2 Installation and Use manual.
4 Install PCIE cards
1. Line up the board-to-board connector of the module assembly
with the board-to-board connector of the carrier board.
2. Make sure that the interconnectors are properly aligned and that
the five standoffs on the module have contact with the top of the
carrier board.
3. From the bottom side of the carrier board, locate the screw holes
on module and carrier board.
4. Use the screws to fasten the module to the carrier board.
NOTE: This installation procedure is only for reference. Assemble
the heat sink and the module based on your own thermal solution.
SCP-P4040-4G-ENP2
Quick Start Guide
P/N: 6806800P61B February 2020 Get More Information
For more information on this product, see the
SCP-P4040-4G-ENP2 Installation and Use manual
and other related technical documentation, which can
be found by using the Documentation Search at
https://www.smartembedded.com/ec/support/.
Technical Assistance
For technical assistance or to report product damage or shortages,
contact your local SMART Embedded Computing sales
representative or visit https://www.smartembedded.com/ec/support/.
© 2020 SMART Embedded Computing™, Inc. All rights reserved. The stylized “S” and
“SMART” is a registered trademark of SMART Modular Technologies, Inc. and “SMART
Embedded Computing” and the SMART Embedded Computing logo are trademarks of
SMART Modular Technologies, Inc. All other names and logos referred to are trade names,
trademarks, or registered trademarks of their respective owners. These materials are
provided by SMART Embedded Computing as a service to its customers and may be used
for informational purposes only. For full legal terms and conditions, visit
www.smartembedded.com/ec/legal.
