SmartPool SUNHEATER S210U User manual

www.smartpool.com 1.1.A
INSTALLATION &
OPERATION MANUAL
How Solar Pool Heating Works Why Solar Heat Works Best
• Using your pool pump, water
is automatically pumped
through the solar collectors.
• As sun shines on the collector,
the water is then heated as it
moves through it.
• The heated water is returned
back to the pool, through
your return lines.
• You enjoy your own
heated pool with no
fuel costs.
• Water is heated as it moves through the many
tubes in the solar collectors.
• Tube and web design traps heat and catches
light as the sun moves across the sky.
• Tough polypropylene material won’t rust, corrode
or scale. Plus, the collector is reversible.
Collector Cross Section
PLEASE READ THIS MANUAL CAREFULLY. YOUR ENJOYMENT OF YOUR SOLAR HEATED POOL
AND YOUR WARRANTY ARE AFFECTED BY HOW YOUR SOLAR HEATING SYSTEM IS INSTALLED
CAUTION: a) Solar collectors are often installed on the roofs of buildings. Unless you are very familiar with working
on roofs and have the proper ladders and safety equipment for such work, you should hire someone with
the necessary experience to do the installation. Failure to observe safe practices on a roof or other elevated
structure may result in falling, leading to serious injury to you.
b) When installing collectors on the ground, do not build a rack support that could allow children access
into the pool.
Product Number S210U

www.smartpool.com
How Well Does Solar Heating Work?
A properly sized and installed system will raise pool temperatures up to 10˚ F/6˚ C during the season. You will only want to
circulate water through the solar collector when the sun is shining. When it's cloudy or rainy, solar won't work as well (and you
probably won't be swimming during those times), but your water will be back up to temperature after one or two warm days.
Do I Need A Special Pump?
If your pool pump is in good working condition, there shouldn't be any problem using your existing pump. A one HP pump will
handle installations up to 30 feet (9 meters) away from the pool equipment and one story up. If the collectors are cool to touch
when the water is running through them on a warm sunny day, you are getting enough flow.
Where Can I Put The Solar Collectors?
Anywhere you get at least 6 hours of full sun during the day. The longer the collectors are in full sun, the better they will work.
If you are mounting the solar on an angle (like a roof or rack), the collectors should face in a southerly direction. For roof or rack
mounting, you will need one SK-43 mounting kit (one SK43 will secure up to two S220U collectors). For high wind areas, we recommend
one SK-34 High Wind Kit for each collector. Call SmartPool at 732-730-9880 for ordering info.
What Tools Will I Need?
• Flat head screwdriver or 5/16" (8mm) nut driver
For roof or rack mounting you will also need:
• Power drill
• 1/8" (3 mm) drill bit and a Phillips head bit
• Silicone sealant (GEII or equivalent)
What additional parts will I need to install the solar system on a roof?
• If your current plumbing is 2” you will need a 1 ½” to 2” PVC adaptor.
• One SmartPool Mounting Kit SK-43 (will secure up to two S220U collectors). One high wind SK-34 for each collector in high wind
areas.
• You will need the correct amount of 1.5” (38 mm) Schedule 40 PVC pipe for the plumbing, going to and from your pool equipment.
• You will also need PVC primer, glue, and fittings (available where you buy PVC pipe).
What additional parts will I need to install the solar system on the ground or on a rack?
• For a ground mount installation you will require 2 hoses - one that will reach from the pool equipment to the collector and one that reaches
from the collector back to the pool.
• For a rack mount installation you will need SmartPool’s mounting kit SK-43. For high wind areas you will need one SK-34 for each collector.
USE ONLY SMARTPOOL-APPROVED MOUNTING KIT SK43
AND FOLLOW THE DIRECTIONS PROVIDED.
FAILURE TO COMPLY WILL VOID YOUR WARRANTY!
IMPORTANT
READ THIS ENTIRE MANUAL BEFORE STARTING
WARNING! POSITION THE RACK SO THAT IT DOES NOT
PROVIDE ACCESS TO THE POOL FOR CHILDREN.

www.smartpool.com
Product # S210U Kit Components
SunHeater collectors are manufactured with
special molds and materials designed to
provide you with the most durable, high
performance solar pool heating system
available. Note: during manufacturing certain
mechanical incisions are required to
complete the assembly of the collector (see
photos on right). These are normal and do
not adversely affect the performance or
durability of your SunHeater.
Please Note: Small
holes in collector (see
photo at right) are NOT
to be used for mounting.
Use only SmartPool-
approved mounting kit
SK43 and follow the
directions provided.
Failure to comply will
void your warranty.
ITEM NUMBER DESCRIPTION QTY
SCPNL210 2' X 10' PANEL 1
SC150CLMP 1.5" HOSE CLAMP 2
SCFLEXADAPT 1.25"-1.5" FLEX HOSE ADAPTOR 2
SC150FFTC 1.5" THREADED COUPLING 2
SC150TEC 1.5" THREADED END CAP 2
SCTEFTAPE TEFLON TAPE 1
SK28 SOFT-SIDED POOL ADAPTOR KIT 1

www.smartpool.com
1. Provide an area that is free of any sharp objects with at least 6 hours of full sunlight a day.
2. Remove strap from collector and unroll it placing the headers with the serial
number label closest to your pool equipment.
3. Allow the collector to relax in the sun (30 minutes to an hour). DO NOT LAY COLLECTOR ON
THE GRASS IT CAN DAMAGE THE LAWN UNDERNEATH! DO NOT WALK ON COLLECTOR.
4. Remove and discard the black protective end caps covering the threaded ends of the header pipes.
5. Wrap the threaded ends of the headers with Teflon tape provided (as shown) for a watertight seal.
6. On the header without the label, thread white end caps on the open ends (as shown). Be careful
not to cross-thread.
7. Thread connectors on the open ends of the header with the label (as shown). Be careful
not to cross-thread. Use couplings and flex hose adaptors or soft-sided adaptor kit (SK28)
8. Turn off pool pump.
9. Go to pool and plug the round return fitting on the pool wall from the inside, so the water won't drain
through (a winter plug works well).
10.Connect a hose from the filter to the lower elbow connector. Always fill the system from the bottom.
11. Connect another hose from pool return fitting to other elbow connector.
12.From the inside of the pool wall, remove the plug you placed in the round return fitting.
YOU ARE NOW READY TO START-UP YOUR SOLAR POOL HEATER
13. Turn on the pump. Check for leaks and tighten the connections that need attention.
Note:Upon start-up you will see air bubbles come through the return hose. This is normal and will stop after all the air
has been purged from the solar heating system.
SYSTEM LAYOUT
Single System
Required:
• Flathead screwdriver or 5/16" (8 mm) nut driver.
• To install your solar heating system
you will require 2 hoses - one that will
reach from the pool equipment to the collector and one that reaches from the
collector back to the pool.
Cool Water
(Feed)
Warm Water
(Return Fitting)
Pool Pump
Elbow Connector
Elbow Connector
White End Cap
5
6
7
White End Cap
Label
Filter
Feed Hose
Return Hose

www.smartpool.com
OPERATION & MAINTENANCE
Operation
1. The collector should feel cool to the touch when the sun is shinning on the collector and water is passing through.
This means that the heat is being transferred to the water.
2. The water returning to your pool will be a few degrees (3-5˚ F/2-3˚ C) warmer than the pool itself. This is the most efficient
way to heat a large body of water like a pool. Keep circulating the water and add a few degrees each pass.
3. Circulate water though the solar collector at least 6 hours per day during the daylight hours on sunny days. If you circulate
your water through the collector at night, or when it’s overcast or on chilly days, you will cool your pool water rather than heat it.
If you need to run your pump at night, divert the water directly back to the pool and bypass the solar system.
Winterization
YOUR SOLAR SYSTEM MUST BE DRAINED FOR WINTERIZATION! FREEZE DAMAGE IS NOT
COVERED UNDER WARRANTY! YOU MUST DRAIN YOUR SOLAR COLLECTORS JUST LIKE
YOU DRAIN THE REST OF YOUR POOL EQUIPMENT!
Remove the white end cap at the top of the solar system. Remove the white end cap at the bottom and be sure ALL the water is
drained out of the system. Replace end caps and blow pressurized air through the system. After blowing them out, remove and
store the bottom end cap for use again in the spring when you start up again. You can leave the collectors in place (as long as they
are completely drained) and they will withstand even the harshest winters. SmartPool recommends that you store your collectors
inside in a warm dry place.
Collector Repair
IF THE COLLECTOR DEVELOPS A LEAK
Your solar collector is warranted against defects in materials and workmanship
(see warranty for details and limitations). If a leak develops for any other reason,
you may use the repair method shown. The collector is not warranted against
freeze damage.
SOLAR COLLECTOR REPAIR
This method allows for an easy and permanent, on-site repair of a collector by
isolating the leading riser tube. Referring to the figure at the right, locate the
tube to be isolated. (End tube has been shown for clarity). Using a sharp
utility knife, very carefully cut away approximately 1" (25 mm) of the tube at
both headers. Drive a #10 sheet metal screw, preferably stainless, into the
hole in the header. The screw must be between 1/2" (12.7 mm) and
3/4" (19 mm) long. DO NOT OVERTIGHTEN! If the screw strips out, or if the
repair leaks, use a #12 screw. This repair method will not void the collector warranty.
With proper care and winterization, you will enjoy your solar collectors for many years.

www.smartpool.com
SmartPool LLC warrant to the original purcha er of the Solar Collector that the company will, at it option, repair or replace any olar collector that prove to be defective in either workman hip or
material upon prepaid return of the collector by the owner to SmartPool, Inc., ubject to the provi ion of the limited warranty tated above, and the exclu ion and limitation et forth below.
SmartPool LLC will, pur uant to the term of thi warranty, at it ole option. either repair the collector at a nominal charge to the owner, or replace the collector per the pro-rated provi ion tated
herein. All repaired or replaced collector will be returned at the homeowner’ expen e. The pro-rated ba i for collector replacement i et forth above.
What is covered: The olar collector i warranted to be free of defect in material and workman hip when leaving the factory.
What is not covered: Hardware; including ho e , clamp and pla tic fitting ; Any damage due to freezing cau ed by or related to improper drainage, winterization, or torage; Damage, defect , malfunction ,
or other failure ari ing from u e of the product which doe not comply with the in truction provided by the manufacturer; Damage, defect , malfunction , or other failure cau ed by or related to repair
performed by any ervicer other than an authorized ervice repre entative of SmartPool LLC Claim will not be accepted for a collector’ damage in tran it unle damage to hipping container i noted at time
of delivery on the tran port company’ delivery bill.
SMARTPOOL LLC SHALL IN NO WAY BE LIABLE OR RESPONSIBLE UNDER ANY CIRCUMSTANCES OR IN ANY AMOUNT FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES OR FOR ANY
INJURY OR DAMAGES TO PERSON OR PROPERTY USING OR USED IN CONNECTION WITH THIS PRODUCT, OR FOR LOSS OF PROFITS OR OTHER COSTS OR EXPENSES OF ANY KIND OR
CHARACTER. THERE ARE NO OTHER WARRANTIES OR REPRESENTATIONS, EITHER EXPRESS OR IMPLIED, WHETHER OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR
OTHER, MADE BY SMARTPOOL, INC., OTHER THAN THOSE SPECIFICALLY SET FORTH IN THIS WARRANTY. NO PERSON, FIRM, OR CORPORATION IS AUTHORIZED TO MAKE ANY
REPRESENTATIONS, OR INCUR ANY OBLIGATIONS IN THE NAME OF OR ON BEHALF OF SMARTPOOL, INC., EXCEPT AS STATED HEREIN. THIS WARRANTY IS IS EXPRESSLY UNDERSTOOD
TO BE THE EXCLUSIVE REMEDY AVAILABLE TO THE PURCHASER, AND THIS WARRANTY CONTAINS THE FULL AND COMPLETE AGREEMENT BETWEEN SMARTPOOL AND THE PURCHASER.
THIS WARRANTY SETS FORTH THE ONLY OBLIGATIONS OF SMARTPOOL WITH REGARD TO THIS PRODUCT, AND THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION
ON THE FACE HEREOF.
The repre entation et forth herein are the only repre entation made by SmartPool LLC with re pect to the product, and thi warranty doe not con titute either a performance or
ati faction guarantee. It i the re pon ibility of the product owner to regularly te t and check the product for proper function and afety.
This warranty gives the original purchaser specific legal rights. You may have other rights depending on where you live.
ALL WARRANTY CLAIMS MUST BE HANDLED DIRECTLY
WITH SMARTPOOL. DO NOT RETURN TO YOUR DEALER. SMARTPOOL
ACCEPTS CLAIMS FROM POOL OWNERS ONLY.
FIVE YEAR WARRANTY
Five year limited warranty from date of purchase with one year full.
After the first year, the claimant shall pay the list price at the date of the claim less one-sixtieth (1/60) of that
price for each full month remaining in the warranty period.
1) Call 1-732-730-9880 to initiate a claim.
2) You will receive an instruction package within 10 days.
3) Please allow 2-4 weeks for warranty claims to be settled.
4) If you do not receive your collector within 6 weeks, please cal SmartPool Warranty
Department Monday through Friday at 1-732-730-9880.
SMARTPOOL SOLAR COLLECTOR
Five Year Limited Warranty
(Valid for North America Only)
To File a Claim:

www.smartpool.com

www.smartpool.com