Smeg GW1160 User manual

GW1160 - GW4060
GLASSWARE WASHER
USER MANUAL

User Manual
GW1160 - GW4060 Series
Page 2 - 75
READ THE USER MANUAL
This manual is an integral part of the appliance.
Take good care of it and keep it to hand throughout the appliance’s life cycle.
This manual and all the information it contains must be read carefully before using the appliance.
Failure to read, misunderstanding or incorrect interpretation of the instructions provided in this manual may lead to
misuse of the appliance, put the operator at risk and considerably reduce the appliance’s performance.
Installation, maintenance and any repairs must be carried out by authorised technical staff.
Repairs of the appliance performed by unauthorised staff may put the user's safety at risk, and
void the warranty cover.
Any components must always be replaced with genuine Smeg spare parts.
The use of the device in breach of the instructions provided by the manufacturer may jeopardise
the specified protection level (safety of the appliance) and the warranty cover for it (see point 5.4.4
of IEC 61010-1:2001).
The manufacturer declines any liability for uses other than those described in this manual.
Consumables (detergents, air filters, thermal printer paper, etc.) are not covered by the
warranty, except for any manufacturing defects.
The Warranty does not cover any parts found to be faulty due to negligent or careless use,
improper use, failure to comply with the appliance’s operating instructions, incorrect installation
or maintenance, maintenance or repairs performed by unauthorised staff or made with non-
genuine parts, damage during transport, or any circumstances in which the appliance’s defects
cannot be traced back to manufacturing faults. Any work relating to installation and connection to
the intake and drain systems, and the maintenance work described in the operator’s manuals, are
also excluded from the Warranty.
Any accessories may not be installed on the appliance by the user; this must be done by Smeg
authorised technical staff.
To request technical documentation relating to accessories from Smeg: [email protected]
(ref. 5.4.4.c IEC61010-2-040:2005)
The information in this manual is provided for guidance only. The contents and the equipment described may be
subject to change without notice.
19 390 4274 00
04/07/2013
Manual Ed.
Date

User Manual
GW1160 - GW4060 Series
Page 3 - 75
INFORMATION AND AFTER-SALES SERVICE FOR SMEG
INSTRUMENTS DIVISION PRODUCTS
Our Sales Department staff will be able to provide you with information about prices and special offers.
Our After-Sales Department will be able to provide you with guidance about keeping your appliance functioning
correctly and put you in touch with your nearest authorised Service Centre.
INTERNATIONAL CUSTOMERS
PLEASE CONTACT YOUR LOCAL DISTRIBUTOR
[e-mail]
[e-mail]
Our whole product offering can be viewed at:
www.smeg-instruments.com

User Manual
GW1160 - GW4060 Series
Page 4 - 75
CONTENTS
1INTRODUCTION................................................................................................................................................... 6
1.1 GW FAMILY - INTENDED USE .............................................................................................................................. 7
1.2 DEFINTITION: “RESPONSIBLE AUTHORITY” IN RELATION TO THE DEVICE.......................................................... 7
1.3 WASHING TROLLEYS AND ACCESSORIES............................................................................................................. 8
1.4 LIST OF MODELS.................................................................................................................................................. 9
2KEY TO THE SYMBOLS USED IN THE MANUAL AND ON THE APPLIANCE .............................................................10
3GENERAL WARNINGS .........................................................................................................................................11
3.1 ACCESSING AND REUSING THE DEVICE AFTER AN INCOMPLETE CYCLE ........................................................... 12
3.2 DOOR OPENING ................................................................................................................................................ 12
3.3 MANUAL DOOR RELEASE PROCEDURE ............................................................................................................. 14
4DESCRIPTION OF CONTROLS AND PROGRAMS...................................................................................................15
4.1 CONTROLS......................................................................................................................................................... 15
4.2 CONTROLS - DETAILED DESCRIPTION ............................................................................................................... 16
4.2.1 A0 PARAMETER DISPLAY........................................................................................................................... 17
4.3 INDICATOR LEDS - INTRODUCTION................................................................................................................... 18
4.4 INDICATOR LEDS - DETAILED EXPLANATION..................................................................................................... 19
4.5 SELECTING THE WASHING PROGRAMME ......................................................................................................... 21
4.6 BRIEF TABLE OF THE PROGRAMS INSTALLED.................................................................................................... 23
4.6.1 RESINS - SOFTENER, REGENERATION AND WASHING PHASE ................................................................... 24
4.6.2 DRYING PHASE –Only for GW4060 series ................................................................................................ 24
4.6.3 CUSTOM PROGRAMS ................................................................................................................................ 26
4.7 A0 THERMAL DISINFECTION PARAMETER ........................................................................................................ 27
4.8 PREPARING THE LOAD FOR WASHING AND DISINFECTION.............................................................................. 28
4.9 END OF CYCLE ................................................................................................................................................... 29
4.10 INTERRUPTING A PROGRAM IN EXECUTION .................................................................................................... 30
4.11 TEMPORARY DISABLING OF DEMI WATER - ON GW SERIES ONLY ................................................................... 31
4.12 RESET PROCEDURE............................................................................................................................................ 32
4.13 PRINTING THE CYCLE AND APPLIANCE PARAMETERS....................................................................................... 33
5SETUP MODE - “FUNCTIONS” .............................................................................................................................34
5.1 ACCESSING THE SETUP MODE / ENTERING THE PASSWORD ........................................................................... 34
5.2 ACCESS AND PARAMETER MODIFICATION ....................................................................................................... 36
5.3 “SET“ PARAMETERS .......................................................................................................................................... 38
5.3.1 APPLIANCE DATA STORAGE, OVERWRITING, “Set -b” .............................................................................. 40
5.4 “CLOC” – DATE AND TIME PARAMETERS.......................................................................................................... 42
6INSTALLATION INSTRUCTIONS ...........................................................................................................................43
6.1 USE OF THE WATER SOFTENER......................................................................................................................... 43
6.2 USING DETERGENT AND NEUTRALISING AGENT .............................................................................................. 44
6.2.1 LIQUID DETERGENT INTAKE SYSTEM ........................................................................................................ 44
6.2.2 DETERGENT LEVEL SENSORS - OPTIONAL ................................................................................................. 46
6.3 USING THE DETERGENT DISPENSER –GW SERIES ONLY................................................................................... 47
6.4 RECOMMENDED DETERGENTS ......................................................................................................................... 47
7ALARMS AND WARNING MESSAGES ..................................................................................................................50
8CLEANING AND MAINTENANCE .........................................................................................................................58
8.1 CLEANING THE DEVICE AND ITS PARTS............................................................................................................. 58
8.2 IF THE DEVICE IS TO BE OUT OF USE................................................................................................................. 60
8.3 REUSING THE DEVICE AFTER A PERIOD OUT OF USE ........................................................................................ 61

User Manual
GW1160 - GW4060 Series
Page 5 - 75
8.4 TROUBLESHOOTING.......................................................................................................................................... 61
9ROUTINE INSPECTIONS AND MAINTENANCE .....................................................................................................62
9.1 DAILY................................................................................................................................................................. 62
9.2 WEEKLY ............................................................................................................................................................. 62
9.3 EVERY SIX MONTHS .......................................................................................................................................... 62
9.4 EVERY YEAR....................................................................................................................................................... 62
10 TECHNICAL DATA ...........................................................................................................................................63
11 PRODUCT DIMENSIONS - MEASUREMENTS IN MM ........................................................................................65
12 POSITIONING THE APPLIANCE ........................................................................................................................65
13 ELECTRICAL SYSTEM REQUIREMENTS.............................................................................................................68
14 WATER CONNECTION FITTINGS......................................................................................................................69
14.1 WATER INTAKE.................................................................................................................................................. 69
14.1.1 WATER INTAKE CONNECTION................................................................................................................... 69
14.1.2 WATER SUPPLY TAP POSITION.................................................................................................................. 69
14.1.3 WATER SUPPLY SYSTEM REQUIREMENTS................................................................................................. 70
14.1.4 PAD ACCESSORY FOR UNPRESSURISED DEMI WATER .............................................................................. 71
14.2 WATER DRAIN ................................................................................................................................................... 72
15 DATA CONNECTION........................................................................................................................................74