SOHO BABY 43065 User manual

1 of 3
30-43065-V-01
ASSEMBLY INSTRUCTIONS
HAMPTON CHANGING TOPPER
Model #43065

TOOLS REQUIRED:
PARTS ENCLOSED IN CARTON
A. Changing Topper (1 pc)
HARDWARE
2 of 3
SCREW DRIVER (Not Included)
30-43065-V-01
Thank you for your purchase!
Remove all parts and hardware from the box and lay on a carpeted or scratch -free work surface.
Do not dispose of any contents until assembly is completed.
(B) Screw 1 1/4"(30 mm) (2 pcs)
Do not fully tighten all screws until all parts are in place.

3 of 3
30-43065-V-01
ASSEMBLY OF CHANGING TOPPER
THIS STEP REQUIRES :
SCREW DRIVER (Not Included)
(B) Screw 1 1/4"(30 mm) (2 pcs)
A. Place the changing topper on top of the dresser.
The holes in back side should be below Dresser
top surface. (see diagram)
B. Insert the screws into the back of the changing
topper and dresser, tighten with Screw driver.
Check to see that the changing topper is secure.

! CAUTION: ANY PAD USED IN THIS
CHANGING TOPPER MUST BE AT LEAST 16
INCHES BY 32 INCHES (41CM X 81CM) WITH A
THICKNESS NOT EXCEEDING 1 INCH (2.54 CM).
! WARNING
FOR CHANGING TOPPER USE
• READ ALL INSTRUCTIONS BEFORE ASSEMBLING CHANGING TOPPER.
KEEP INSTRUCTIONS FOR FUTURE USE.
• FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY OR DEATH.
• CAUTION: THE PAD INTENDED FOR USE ON THE CHANGING TOPPER SHALL HAVE MINIMUM DIMENSIONS
OF 16 INCHES BY 32 INCHES (41 CM X 81 CM) WITH A THICKNESS NOT EXCEEDING 1 INCH (2.54 CM)
• THE MAXIMUM WEIGHT SHALL NOT BE GREATER THAN 30 LB (13.6 KG).
•DO NOT USE CHANGING TOPPER IF DAMAGED OR BROKEN.
• PLEASE CLEAN THE CHANGING TOPPER WITH A DRY CLOTH AND USE MILD WOOD POLISH IF REQUIRED.
FALL HAZARD
• TO PREVENT DEATH OR SERIOUS INJURY, ALWAYS KEEP CHILD WITHIN ARM'S REACH.
• ALWAYS SECURE THIS CHANGING TOPPER TO THE CHANGING SURFACE BY ATTACHING IT USING
THE SCREWS PROVIDED. SEE INSTRUCTIONS.
• THE SURFACE USED SHOULD BE LEVEL, STABLE AND STRUCTURALLY SOUND WITH MINIMUM SURFACE
DIMENSIONS OF 45.25.INCHES (114.93 CM) BY 17.25 INCHES (43.81 CM)